Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
Hi to everyone, i will try to explain everything in detail.
I developing a product that is currently in the pre-production stage, and im having some issues with voltage...
Hi,
I was testing the BLE_GATTC_EVT_WRITE_CMD_TX_COMPLETE event and I did trigger the event but i was wondering if that it's normal that It triggers after I send all my...
If this has an answer, I did not look as one loses position if one checks.
IN any case, I have a working application running on the PC that uses the pc-ble-driver to access...
Hopefully a simple question: is it possible to define a vendor-specific sensor type for the standard Mesh Sensor Model?
The nRF Connect SDK documentation seems to be confused...
Hi,
as I said before I am working with nRF52832. I can connect with nrf and program it. for example I can make an LED to blink. but when I run the esb_ptx example the program...
Hy.
I use nRF24L01P+ in many projects. I buy it in the form of a pre mounted board, with an LNA on board, for ex. from this site:
http://www.icstation.com/24ghz-ml01dp5...
Hi Sir,
For nRF52840, we have a layout guide, nAN-40, can reference.
For nRF9160, do we have the information of land pattern or similar document can reference?
Thank...
Hi,
In a project I am working on with the nRF52840 I will need the ACL to protect a private key in the flash memory. With help from another post here I put together the...
Hi,
I am using an nRF9160 dev-kit and I am debigging some connectivity issues.
Unfortunately there is some random bahaviour on the Serial Interfaces, which are exposed...
I am a recent student interested in Nordic. I know that my skills are very, very poor. Sorry for asking this question T_T I want to use i2c sensor vl53l1x. I tried to refer...
Hello,
I am developing a Zigbee coordinator with the nRF52840 DK and with the nRF52_SDK_for_Thread_and_Zigbee_v_4.1.0. I flashed the CLI example and everything works fine...
Hello,
could you advice me where can I find description of nRF5 anomaly 211 - the one described in nRF5 SDK 17.0.2?
Citation from 17.0.2 release notes:
...
...
Hi,
I intend to use the DFU BOOTLOADER in my product.
I’m using a PCA10040 DEV board for the tests with S132
I download the nRF SDK V17 and I compiled and I tested the...
I understand that nRF-9160 DK has Segger J-Link to program target devices / custom boards. Can this be used to program any ARM Cortex Debug Connector (10-pin)? Or I can program...
