Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
Hi there,
is there a way to follow multiple devices or is it limited to just one device to follow?
I fit's possible some example would be great :-)
kind regards
Running...
I have trying to test out the latest alpha build (v0.7.0-15.alpha) of the modem firmware with a board that I have been previously running some tests on and which the original...
Hi all,
I creat a main task to process events, when the bluetooth connected, this main task can not work, and the bluetooth can still work.
I try to add the main task...
Hello
This is sumanth. I am working on implementing battery model in light switch program(mesh), I enabled the battery model in client and I would like send the battery...
Hi, in the documentation for this module there is no stencil design specification or recommended
reflow profile. My earlier experience of LGA-modules says I really need...
Hello,
I want to get the IP address of a CoAP request source (server). According to me, it is close of the objective of the client / server pair mechanism example. So...
Hi, I'm having problems negotiating DLE with a nRF52840.
I'm sending a LL_LENGTH_REQ (251 octets and 2120ms time) to nRF52840 from an ESP32.
According to the spec. those...
Hi
I am using nrf52832 dev kit.
I have configured my device to act as peripheral. i want to discover services offered by central devices whichever connects to my device...
I am trying to use the PA/LNA using the pc-ble driver. To do so, i need to configure GPIO and the softdevice. I found examples:
https://devzone.nordicsemi.com/b/blog/posts...
I'm wondering about how the notification queues are allocated when setting hvn_tx_queue_size using ble_cfg.conn_cfg.params.gatts_conn_cfg.hvn_tx_queue_size.
If I set it...
\components\iot\socket\api\socket_api.h contains a definition for 'struct timeval' that conflicts with \arm-eabi\sys-include\sys\_timeval.h
It creates a conflict with including...
Hi,
This thread discusses how to change the Makefile to interact with the Segger Systemview ( https://devzone.nordicsemi.com/b/blog/posts/instrumenting-with-segger-systemview...
Enabling or disabling notification on Client does always lead to an update of local database of Server by writing to its flash memory. Particularly NUS requires enabling of...
Hi,
I'm following this tutorial . In challenge 1, I was asked to change the transmit power level of the device.
Challenge 1: Try to add and populate the "p_tx_power_level...
