Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
Hi,
I'm developing an application using the timeslot API for a custom radio protocol. The application also uses a number of the nRF52832 peripherals, as well as the app_scheduler...
Hello,
I'm having an issue with scripting AT comands directly into the code of the nRF9160. I'm a novice at all this so I apologise if the mistake is an obvious one.
Inside...
I get "ERROR: There is no debugger connected to the PC with the given serial number." when I run e.g. nrfjprog --eraseall on command line.
Programming/debugging using VisualGDB...
Hi,
The User Guide v1.3 in Chapter 2 (minimum requirements) states "SEGGER J-Link Software" under "Software requirements". Is there J-Link software specifically for use...
I've been developing firmware for the nrf52840 for a few months using armgcc+openocd+arm-none-eabi-gcc working successfully. I recently upgraded my ubuntu version (18.04)...
Hi,
I am trying to connect to cloud MQTT (cute cat) which needs username and password for authentication. In the sample the password and username is set to NULL in client_init...
I'd like to create pc program connect to nrf51 device.
In Many document as I found, describe with dongle/DK and using a virtual com port like this.
PC -> dongle/DK include...
Hi,
I have some questions about application operation while in PSM / eDRX mode.
1. when modem is in deep sleep mode, is the application halted too ?
2. if not, what...
Hi, I am using nRF52 as a central SDK15.2 and SD132. I want to add in peripheral mac address which I want to put in the whitelist manually from the UART. But the example that...
Hi,
I read on the forum that DMA for UART block is not possible on nRF51. Is it true?
If yes, is there any way that we can enable this? Our application demands DMA for...
We developed device based on nrf52840 and android app based on nrf uart v2.0. The application runs very slow in google pixel 2xl., oneplus3 etc thich are updated to latest...
I'm working on certification for a product which uses an nRF52832 chip. I've found https://launchstudio.bluetooth.com/ListingDetails/14830 , which it seems I can use for the...
Hello,
I followed getting started guide given in the link below,
https://devzone.nordicsemi.com/tutorials/b/getting-started/posts/getting-started-with-nrf9160-dk
I started...
(there isn't an option for nRF Android or Mobile when creating a case!)
Next to each Characteristic is one or more little arrow icons:
Where is the documentation which...
