Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
I need to use a burst write i2c function to write the dmp library for the MPU6050 gyroscope.
The current function that I've been using does not work for this case:
And...
Hi
I am using Ubuntu 16.04 and the latest version of nrf Connect for desktop and JLINK. Initially, there were some errors related to the serial port. Once I upgraded JLINK...
Hello!
On the Nordic website there stands that Keil is supported. So I am currently using it throw the Package but i got a problem with the correct partitioning in Keil...
HI ,
I have built a mesh based network based on the light switch sample.
Now I'd like to take it to the next step - I'd like the pass 70 Bytes of data between nodes (...
I am using the nrf51-dk on windows 10 and I tried to apply the latest mbed bootloader. After I do that and restart the chip, the device seems to mount and dismount repeatedly...
hi all
i want to make BLE peripheral app for send data to via UART but i don't know about which sample good for my purpose? so please tell me which sample good for my requested...
Hello
I have a very strange behaviour with debugging the mqtt_simple example for the nRF9160. The example is crashing in debugg configuration. (This happens with Segger...
I am using Nordic SDK 14.2.0 with the pca10040 and I want to integrate the Buttonless DFU functionality into my project (started with the Nordic BLE app template).
I tested...
Hi All
I want to add some custom source files (.c) & header files (.h) to an existing project.
I tried adding it by right clicking "Project app/libapp.a" branch of the...
I'm getting started developing an app for nRF52811. have worked with nRF52832 before. I was wanting to start my development on top of the basic ble app template project, from...
Hi,dear engineers,
I refer to the examples in nRF5_SDK_14.2.0_17b948a\examples\ble_peripheral\ble_app_buttonless_dfu\pca10040\s132. I Port it into my own program. it seem...
I try to send the NRF_LOG_INFO() messages over a own backend interface. I tried to add a new backend with nrf_log_backend_add() and enable it with nrf_log_backend_enable(...
I am trying to do Secure DFU through WebUSB [1] . I need suggestions to move forward.
Some starting points I found :
DFU Protocol
I did saw that SDK 15.3.0 outlines...
Hi all
nrf52840 Development board,sdk is nRF5_SDK_15.2.0_9412b96 ,PC is windows 10 .My testing master device is cell phone(Huawei HTC and so on,android system),and using...
