Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hey guys, I have a question.
Please tell me.
I use the BLE module implementation of the nrf51822.
Now, I try to use sample program "ble_app_hids_mouse" for s110.
I want...
Hi,
I have a application that receives the Epoch time from the Android Application and increments every second. and needs to store and increment the Epoch Time value even...
We just locking for your mesh protocol...
Can mesh example source communicate Ping_pong, Scaling_example, Template by using BLE_Gateway?
Please let me know...
I am using sniffer to monitor the BLE packets.
I noticed that when master is reading the list of the characteristics, sometime there are 2 handles involved, sometime there...
I'm setting up the nRF52 environment on Linux. I have previously used the pure-gcc setup with the nRF51 and that currently works, but since the nRF52 came with all the GCC...
In nutshell, I intend to achieve
Buttonless DFU over BLE on a custom
board with SDK v10.0.0 and Softdevice
v8.0.0 with bonding retained.
On this custom board...
Hi,
I am attempting to make a PCB for NRF51822 and I was wondering how I would upload a bootloader to the chip? I can't seem to find it. The device in the end will be using...
I checked several (not All) Keil nRF SDK 11.0 Ble_pheripheral examples and the S132 softdevice Hex File doesn't seem to be in the project any more.
The flash softdevice target...
Since the Intel Curie SoC integrates a nRF51822 circuit, it would be great to program it. Being that the canonical OS for Curie's (current) reference platform 'Genuino 101...
I ran watchdog with this code:
void wdt_init(void)
{
NRF_WDT->CONFIG = (WDT_CONFIG_HALT_Pause << WDT_CONFIG_HALT_Pos) | ( WDT_CONFIG_SLEEP_Run << WDT_CONFIG_SLEEP_Pos...
Hi, I'm trying to get pairing working. So far I have set the following in nrfgo studio:-
Device security: security required
Required level of security: Authenticated...
I am from a Chinese company which produce power supply, I plan to use your product and try to download the APP for my Android phone(Sumsung A8). However, I can't download...
Hi,
I would like to add DFU support to my product.
How can I protect from people producing/buying counterfeiter boards and flashing my software on these boards ?
Do...
Hi,
I implemented two services, now I have the following problem. Each service is working standalone, but when I put both together only the first initialized service works...
