Is there a way to recieve more than one write callback for a given characteristic, per radio session? It seems like I can rx 1 time per attribute per radio session and tx...
If it can work with iOS blue setting will be better
I need some reference to dev hid device in IOS
but I can just find my device ,connect ok but not work.
I need to create timeout below 1ms. I would pretty much like to use timer for that because I do not want to hold the cpu inside cycle. For me it is not important the exactness...
Hi,
While testing the device firmware update through the nRFtoolbox android application, i get "device has no required service" error more frequently.
I use latest version...
I'm having some trouble successfully entering ON,IDLE mode. I have pared-down my application to do the following:
Initializes the app_timer using the scheduler:
...
I want to control GPIO toggle by PPI. Timer1 is in timer mode. CC[0] is 1000, and CC[1] is 8000.
I use compare[0] to toggle gpio18 by PPI. I also want to use compare[1] to...
Hi,
I use two evk board to connected and test the uart serialization sample(ble_s110_serialization), one is ble_app_hrs and one is ble_app_connectivity. But I have one...
Hello,
On nRF5340, sdk v1.6.1, I use this function to send data to center via BLE:
ble_data_send ( ble_connection, data, 182 );
and here is the definition of the function...
I build an app Android using BLE lib Nordic version 2.1.1, How can I read the RSSI of the device after my app is connected with the device?. Thanks All
Hi,
How should we interpret this XMONITOR response with regard to PSM:
%XMONITOR: 5,'vodafone.de','','26202','BBA6',7,20,'01442801',240,6300,37,40,'','00001000',' 111...
Hi my application will be based on nRF52820 and has only USB connection (no BLE). I'm developping with nRF5_SDK_17.0.2_d674dde and a nRF52840 devkit. The end user should be...
I'm having trouble driving the BMI088 with the official driver of Bosch BMI088 (link to this driver) in the ble_app_uart routine. I never get the chip ID. Bosch BMI088 official...
Hi, Aim :- To Configure SAADC Sampling Rate at 200Khz. SAADC Configuration :- 1. The resolution, oversample, interrupt priority and low power mode are set as 12 bit, OFF,...
Hi,
I am planning to design a device based on nRF51-dk but with external programmer. I have ST-Link available so I thought I just provide a simple walk through showing...
Hi, all
I tested nRF5_SDK_17.0 ecdh example (path: \examples\crypto\nrf_crypto\ecdh), config with MBEDTLS, CC310, uECC separately and add a gpio toggle to measure timing...
