Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
I am working on an existing Bootloader project, it uses the Bootloader from the SDK with added custom thin layer on top of it. It runs on a custom board.
I can see the debug...
Hello all,
I am using the Application Timer (as written in https://devzone.nordicsemi.com/nordic/short-range-guides/b/software-development-kit/posts/application-timer-tutorial...
Hi,
Developing on nRFConnect/ZephyrOS and looking to enable multi-threaded debugging using pyOCD firmware on nRF52 DK, since not currently/yet supported by JLink.
Was...
I used nRF 52840 dongle as a central device on windows 10. I use it to pair with remotes we have. I develop it base on https://github.com/NordicSemiconductor/pc-ble-driver...
Hello Folks,
We are facing an issue in the NRF52832 Bluetooth connection of our self fabricated PCBs. The PCB designs were based on the Sparkfun NRF52832 dev board designs...
Basically the same question as here:
https://devzone.nordicsemi.com/f/nordic-q-a/45557/getting-status-messages-from-mesh-to-phone
But the answer there doesn't really tell...
Hi Team
we are trying to use the example given in SDK 16.0 and I am able to write and read properly.
But when I want to write/erase my eeprom entire page (256-byte Page...
Guys:
I´m developing my own board with nordic 52382 and I´d like to know if a series resistor needs to be connected to SWDIO and SWCLK lines on board to connect to SEGGER...
Hello
Is any tool available for dynamic code analyser which supporting the ses project?
I have nrf52840 freertos project. I want to check my code for memory leakage and...
hi,
I am working on nrf52833 dfu. right now I received an error
raise NordicSemiException('Extended Error 0x{:02X}: {}'.format(resp[3], data)) pc_ble_driver_py.exceptions...
Hi,
I am working with Ubuntu 16.04 TLS.
I downloaded the "nrfconnect342x8664.AppImage" file and installed the .deb package of JLink_V682g.
When I start the "nRF Connect...
1.1. In function: poll (fds, ARRAY_SIZE (fds), cloud_keepalive_time_left (cloud_backend) ); How to detect actions that perform socket disconnections locally.
2. I queryed...
I faced several troubles when I worked with Bluetooth: Mesh sensor client and Bluetooth: Mesh sensor server examples. Firstly, I couldn't build the application "Bluetooth...
Hi, i want to flash my modified code in my customized boards , which hex file should i use for flashing the customized nrf52832 board usinf nRF CONNECT . I need a hex file...
