Hi,
I use the nrf51422 chip.I want to know if the ANT establish link between chips,where can I get the matching configuration (like device type、channel ID).I mean is...
Is there a way to recieve more than one write callback for a given characteristic, per radio session? It seems like I can rx 1 time per attribute per radio session and tx...
If it can work with iOS blue setting will be better
I need some reference to dev hid device in IOS
but I can just find my device ,connect ok but not work.
I need to create timeout below 1ms. I would pretty much like to use timer for that because I do not want to hold the cpu inside cycle. For me it is not important the exactness...
Hi,
While testing the device firmware update through the nRFtoolbox android application, i get "device has no required service" error more frequently.
I use latest version...
I'm having some trouble successfully entering ON,IDLE mode. I have pared-down my application to do the following:
Initializes the app_timer using the scheduler:
...
I want to control GPIO toggle by PPI. Timer1 is in timer mode. CC[0] is 1000, and CC[1] is 8000.
I use compare[0] to toggle gpio18 by PPI. I also want to use compare[1] to...
Hey,
So I recently got some test SIMs from AT&T to use for our development. I'm trying to get them working with my nRF9160 dev kit but can't seem to get a connection to...
This question has been asked several times but none of the answers is solving my problem. I am developing a ble application which was loading with no problems. I switched...
Hey,
I neet to change the PHY mode of my connection between nRF52840 DK and OnePlus6 (Android 9) to CODED PHY. If I try to change it, I'm always getting an fatal error and...
An ARM sales rep told me the CryptoCell-310 was discontinued and replaced by CryptoCell-312. Assuming this is true, what encryption module will nRF52840 be using in future...
Hi
I added print on line 245 and on iphone 6 can receive complete image data and display but on Iphone X , iphone X Max the data will stop before image data complete
https...
Does nrf 52840 have an inbuilt temperature sensor? I am getting some values when i see them through hercules software, so are these garbage values or internal board temperature...
Hello, I am developing a BLE application using nRF51822 on SDK 12.3 and SD 2.0.1.
I have an application with NUS service, in which I set the device name by sd_ble_gap_device_name_set...
Hello, I would like know if it is possible to play a buzzer using the Low-power PWM Library ? I am using the nrf51 DK and Softdevice130. The SDK I use is version SDK V 12...
Hi,
I just had a quick question - currently I'm using standard drive mode for everything, however in one case I'm driving an IR transmitter that could really do with a...
Environment: Ubuntu 18.04 Desktop with GNU ARM toolchain (gcc-arm-none-eabi-7-2018-q2-update), nRF5X SDK (nRF5_SDK_15.0.0_a53641a), nrfjprog , J-Link device and PCA10056 ...
Hi,
Device should run clock without stopping.
So one of RTC should run.
And device will run NUS peripheral.
In such conditions, i know that i should not use sd_power_system_off...
Hi, I am trying to develop my own board with on board nrf24L01+ coupled with ATMEGA328p . I want to know if there is any schematic of the same in EAGLE or if you have the...
Hi, I try to read data from the ICM20948 IMU with I2C from my nRF 52840 DK.
Initialization of the device is correct, the IMU ID is sent to nRF correctly which means that...
