I want to control GPIO toggle by PPI. Timer1 is in timer mode. CC[0] is 1000, and CC[1] is 8000.
I use compare[0] to toggle gpio18 by PPI. I also want to use compare[1] to...
Hi,
I use two evk board to connected and test the uart serialization sample(ble_s110_serialization), one is ble_app_hrs and one is ble_app_connectivity. But I have one...
I am getting get BLE_EVT_USER_MEM_REQUEST and BLE_GAP_EVT_CONN_PARAM_UPDATE event, when writing to ble device, sample code did not handle these event, and seems no document...
Hello:
Why do I erase SDK5.2 version of flash and read not, in SDK4.2 can. I tested nrf51_sdk_v5_2_0_39364\nrf51822\Board\nrf6310\flashwrite_example is a good example.However...
before i write the flash, it has been erased.so ,its value is all 0xff.
when i write 0x00 to flash address 0x0001,the value read out is not 0x00 but 0x01,and the value in...
I'm looking for a way to use the nordic uart service ( devzone.nordicsemi.com/.../ble_sdk_app_nus_eval.html) from Linux using the native Linux BLE Stack (BlueZ). My application...
I would like to run a SPI program that reads data from a non Nordic chip. I would like to then take the data I received over SPI and send it via BLE.
Are there any code...
I'm trying to place my device in a low power mode for shipping. I used Logging and CLI while its in operation, but I'd like a way to enable/disable the CLI+Logging over BLE...
I'm testing a simple program below, which writes three params followed by read the three params.
Each params is set in tx_buf correctly, but nvs_write does not seem to work...
I am developing a hand-arm vibration sensor for read-out via BLE
Development platform NRF51822 and S110
I'd like advice on how to configure the softdevice and the two...
Nrf52832 sdk15.2 is debugged online after burning softdevice, bootloader and bootloader settings. In the ble_dfu_buttonless_async_svci_init() function, the error NRF_ERROR_SVC_HANDLER_MISSING...
HI,
The nordic MCU I am using is NRF52832.
I am flashing the example code ble_app_uart which is coming in the directory "nRF5_SDK_15.0.0_a53641a\examples\ble_peripheral...
Using Telia APN the following is added after bsd_init()
AT+CGDCONT=0,"IP","lpwa.telia.iot"
However, this AT command sent on the AT socket fails with "ERROR". Does the...
I have 2 client nodes and 1 server node . How can i possibly recieve packets more than i send. I sent 114 packets from 1 node and 104 from another . I am receiving 302 packets...
We are developing Beacon using NRF51822 SoC.
Basically We want to classify our beacons from other manufacturers and want to give our each beacon an unique ID. Please provide...
Hello,
I am new to nrf52832 ,
My question is how to start the timer when external interrupt was rise and turn off timer again when external interrupt was rise
Kindly...
Hello to everyone.
I'm working with Light_switch example in Mesh 3.1, with nRF52832 SDK (PCA10040). I'm trying to stablish communication from server to client, sending a...
Hi everyone,
I'm trying to understand how BLE connection interval works and why my long read is so slow. My slave is nrf51822 with Softdevice 130 v2 and nRF5 SDK v11,...
