Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
Hi, I cannot install nRFgo Studio 1.17.0.
Installation rollbacks during the installation of libusb 1.0.
My pc has Windows 7 64bit with .Net Framewrok 4.5.
No boards are...
I can't make sniffer working with my HW, everything seems to be working correctly and as described in the help file, but I've never seen any sniffed packet yet. So I've decided...
Hi Guys,
since yesterday i am trying to get the DFU with Softdevice S110 (BLE) v7-alpha3 working but haven't succeeded yet. My process is the following:
s110_nrf51822_7...
Hi All,
i would like to know about
1) what is channel in nrf51288?
2) is there any mathematical relationship between channel no and pin no as in ble_app_hrs
example channel...
Hello,
We're looking for easy way to communicate between nRF51822 configured as central part with C# application.
Ideally we should use standard firmware which forwards...
Hi,
Im trying to monitor the high voltage im generating with PWN using ADC. I also need to run BLE at the same time to provide results.
So far I dont have any luck and...
Hi,
Why you use a Hex format file for the firmware with a Toolbox Android, then the IOS Loader you use a binary format file ?
Because I would like use the same file. ...
I have a nRF51822 and arduino uno board. Is it possible to connect my nRF51822 uart to the arduino rx/tx, so that i can use it for communication to PC through arduino. The...
I'm having some problems when flashing the mbed enabled nRF51 kit. This is currently my environment:
When I try to download the file I always get this error: "Cannot Load...
Hello all,
I have two services which has characteristics with indication only property. I am using sensor simulator to generate values. When i write first CCCD write of one...
Hello,
I have been searching for GPIO documentation, particularly on interrupt configuration, and I have come up short. Can someone send me a link where I can find more...
As we know, there is a solution of wireless charging in nordic. I just want to know where is the Bluetooth stack in the solution? In SOC or in Bluetooth controller? If In...
Hello,
I am using nordic development kit nrf51822 and i was trying some examples of it as given. But in that in one example there is one function
static void gpiote_init...
