Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
Dear Nordic Bluetooth experts,
In the Android-nRF-Mesh-Library , is there a way to mark a unicast address as used? The reason why I'd like to do it is the following: When...
Hello, All,
I am using nRF9160 for product development and would like to know a few more important parameters:
What is the power consumption of an NB-iot network using...
Hi There,
I want to connect programable pins on nrf52840 chips in the schematic.
Can you tell me which pins are for programming and debugging?
Best,
Gaosheng
What does this error mean?
<error> app: ERROR 3735928559 [Unknown error code] at c:\nrf\modules\nrfx\hal\nrf_gpio.h:492 PC at: 0x00033D23 <error> app: End of error report...
We need to update our app to accommodate Android 12, but the DFU library has not been updated and crashes when we initiate an update.
Full details are in github-bug: https...
Hi,
we want to run your example of AoA
https://developer.nordicsemi.com/nRF_Connect_SDK/doc/latest/nrf/samples/bluetooth/direction_finding_connectionless_tx/README.html...
API doc says
Specs says:for ed_threshold:
PRF[dBm] = ED_RSSIOFFS + ED_RSSISCALE x VALHARDWARE
ED_RSSIOFFS is -92, ED_RSSISCALE is 4.
So if I want to set the threshold...
Hi DevZone,
1. Description:
I am going to use the nRF9160 SiP in a project on a custom PCB which will house the (LN60G840F, which has an nRF9160 on it). The application...
Hi support team,
I have a nrf 51822 beacon black version and developing with nRF5SDK1230. i'm learning about update firmware for it over BLE. i try to run example dfu/bootloader_sercure...
Hello,
I'm using an nrf52dk board and I am trying to get the RSSI value, and it works fine with the nrfconnect app, except that the the transfer doesn't start at the first...
Hello guys,
I want to work with NRF Mesh but I need help with answering some general questions:
1. Is the current version of the SDK ("nrf5_SDK_for_Mesh_v5.0.0_src") power...
HI,
In my custom board of nRF52805 , I am able to program basic UART application. chip is also generating internal voltages on DEC1 & DEC2 lines.
But i am not able to...
Hi,
I would like to include the direct test mode in my default application that runs the BLE stack. Is this possible ? Ideally I am implementing a custom NUS like service...
