Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
Hi ALL:
- SDK version: nRFSDK 15.3
- HW: nRF52832
I am tried to earse the flash by sg_flash_page_erase(uint32_t page_number), but still failed. My code snippet as...
Hi there,
I want to read the memory from nRF52840,
but J-Link showed me, J-Link is defective, how can I rectify it ?
It's from 2018 J- Link ,
Screenshot :
tha...
Hello,
I'm running the nRF Mesh SDK 5.0.0 with the light CTL LC server example. I have also developed an implementation of a DALI master. DALI is a manchester encoded signal...
I am using: \examples\ble_peripheral\ble_app_uart and \examples\ble_central\ble_app_uart_c .
In Nordic infocenter it says: The application scans peripheral devices and connects...
Hello all,
I would like to know if it would be possible to simultaneously use 3 instances of I2C and 2 of I2C for the nRF5340DK. As stated in the data sheet, the application...
I use nrf52832 + ncs1.7.0 to develop mesh projects. The current project requires mcuboot + mpsl. But I found that SoftDevice Controller occupies too much flash space, which...
Hi,
I am trying add existing file in CMakeLists.txt a main.cpp file inside Project libapp.a, at which i am getting this python error. Kindly help.
Regards,
Hi all,
I am currently using Raytac dongle https://www.raytac.com/product/ins.php?index_id=89 with connectivity FW on the dongle and pc-ble-driver version 4.1.4 and sd_api...
Hi,
I am trying to edit my bootloader (buttonless USB DFU).
I want to add a button to exit the bootloader and return to the app.
The problem is that the gpiote interrupt...
Hi Team,
We are on the Pre-Production stage of our Product, which uses the nRF52840 (forBLE) with the FEM nrf21540(new)
We are aiming to get power out of 20dBm.
To get...
I observe issues when trying to use the datetime lib on the board qemu_x86.
I get the following page fault:
This is reproducible and happens shorty after successfully...
Hello all,
I am migrating our FW NRF52832 from SDK11 to SDK17. (Actually I am starting from scratch on 17). Here I have two characteristics with only read properties (e...
To the kind attention of Nordic support team,
About nRF52833 product specifications (8. recommended operating conditions)
"Note: The on-chip power-on reset circuitry...
