My sensor is off-standard,so I have to use gpio to read and write my sensor.
Gpio IIC will take about 0.5ms to get data.
My app need send data every 7.5ms,it seems that...
Hi,
My android Proximity application fails on service discovery only for the very first time it connects with the devices(nrf51822 evaluation kit with sdk 5.2.0). Actually...
Has anyone converted the app note AN34 DTM Python script to C# or C/C++ ?
The Python DTM script is works OK with the setup specified in the app note AN34 figure 2, which...
Hi,
I have a serious problem, when I use uart of NRF51822 QFAAC0 to receive data from another MCU, I found that it will lost one bit at same position everytime. my SDK is...
Hi,
I just started to interface the lcd display with nrf51822 evaluation board. The display i'm using is, spi compatible, 18" tft (160x130) from tiny lcd. I took spi master...
Hi,
We are using the nRF905 device in an application where it needs to switch between auto-retransmitting and sending single packets, due to it communicating with several...
I would like to figure our how i can send MQTT packages over a Thread network using a nrf52840DK. And to begin with only between two nrf52840 devices.
I am using the nrf...
Hi
I'm testing RC3 of NRF Connect SDK v1.6 in combination with our application. I have an issue with the configuration when I want to enable CONFIG_LTE_LINK_CONTROL. This...
Hello, I work with nrf51822. I need to use ble to control several LEDs. The control logic for each of them is the same. I am creating my own service to control a single LED...
Hi,
After we complete a OTA update via iOS in Objective-C we can't get the BLE to function afterwards. Admittedly, I haven't taken a deep dive into it yet but was curious...
Hi we are integrating a ANNA-B112 device from u-blox that use the nRF52832 core. The pin mapping for UART appears to be different for the Software (not open source) that they...
I have a general question that I haven't been able to clearly locate in documentation. How does the processor handle "traffic" jams from within the different app timers? ...
Hi everyone, so I have been trying to enable the nRF52840 to send notifications to the Nordic Connect app via a custom characteristic. The app can detect the custom service...
Hello,
I have an issue opening the power profiler kit 2 on my windows desktop:
Somethimes it works after restarting, but stops working after a few minutes.
After it...
With a baudrate of 1000000, when i transmit 2 subsequent packets (with ACK), i have to put a delay of 0.2 msec or more. Otherwise the second packet will get ACQ packet acknowledge...
We're trying to debug an issue with our nRF52 chip when pairing to some Android phones. On the nRF52 we are connecting to mobile devices by acting as a peripheral for the...
Dear friends,
I used a serial bootloader by this tutorial Secure DFU Bootloader over Serial Link (UART) , i can upgrade my application with the pc nrfutil tool, the nrfutil...
Hi sir,
I have a question for Bluetooth 5.1 single mode. As I know, above Bluetooth 4.0 has single mode and dual mode. Single mode only supports LE and dual mode supports...
