Using S120 V 8.0.0.3 alpha, processing a BLE_GATTC_EVT_READ_RSP,
received 0x16 bytes of data but there is more to read. Next call to
sd_ble_gattc_read using the same connection...
Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
So, I am using the NRF51 as a SPI slave for an RPI3B+. On a l ogic analyzer and O-Scope the Pi is sending its MOSI SPI data perfectly fine. On top of this issue the nrf_drv_spis_buffers_set...
Hello,
In nRF51 SDK & nRF52 SDK, is there any option to identify/differentiate each & every profile in multi-profiles application for Application Developer??
Thanks.
I am porting software built with SDK 14.2 to SDK 15.0
It looks like some files have been moved from "components/drivers_nrf" to "integration/nrfx/legacy". The first one...
I am trying to merge ble_app_uart peripheral example to ble_app_uart central to make it as to work both central and peripheral at a time.
I am using nrf52 boards and SDK15...
ble_sdk_app_blinky
Test using nRF Connect
You can also test the application with nRF Connect by performing the following steps:
Compile and program the application...
Hello Nordic support team, I broadcast data each 1 second and I use the following function (as used in many examples) to manage the power consumption. Unfortunately, I measure...
In your example you use as data type 0x09 and I dont understand why.
if I look on the Mesh Specification Mesh Beacon AD Type format
0x00 Unprovisioned Device beacon 0x01...
Hello, i have a central card nrf52840 and several peripheral cards nrf52840.
I have a program that allows me to launch the timer on the central and peripherals at the same...
Hello, I am using Linux as a central and I created python app (bluez, pygatt) which simulates the Android Blinky app. It communicates with the board and writes on the led...
Hello,
I have just started out looking into BLE and have read various articles and a book about the protocol itself. I have got a NRF52DK board and am working on a project...
Hello,
I have a problem with the NRF9E5 (cannot be selected in the list).
For several years we have been using the mentioned chip without any problems. Now we want to...
I am using BLE mesh SDK V1.0.1. I want to know the answers of following questions,
1. What are the advertising and scanning parameters used for flooding in Mesh?
2. Does...
