I want to control GPIO toggle by PPI. Timer1 is in timer mode. CC[0] is 1000, and CC[1] is 8000.
I use compare[0] to toggle gpio18 by PPI. I also want to use compare[1] to...
Hi,
I use two evk board to connected and test the uart serialization sample(ble_s110_serialization), one is ble_app_hrs and one is ble_app_connectivity. But I have one...
I am getting get BLE_EVT_USER_MEM_REQUEST and BLE_GAP_EVT_CONN_PARAM_UPDATE event, when writing to ble device, sample code did not handle these event, and seems no document...
Hello:
Why do I erase SDK5.2 version of flash and read not, in SDK4.2 can. I tested nrf51_sdk_v5_2_0_39364\nrf51822\Board\nrf6310\flashwrite_example is a good example.However...
before i write the flash, it has been erased.so ,its value is all 0xff.
when i write 0x00 to flash address 0x0001,the value read out is not 0x00 but 0x01,and the value in...
I'm looking for a way to use the nordic uart service ( devzone.nordicsemi.com/.../ble_sdk_app_nus_eval.html) from Linux using the native Linux BLE Stack (BlueZ). My application...
The provided module spi_master.c has timeout code and error returns from spi_master_tx_rx(...)
Given that there are no external control signals to the SPI block, only a...
Hi,
I am novice to this MCU development world. I have lots of programming experience with desktop/web services side.
I recently received my nRF51822 mBed development kit...
I would like to store some configuration data on non-volatile memory in nrf51822.
I'm using pstorage library to access flash, but I have problem with api calls. What I am...
Hi,
I'm developing custom PCB with nrf51822 (low voltage mode) and I have troubles with flashing the chip. I cannot see the chip in nRFgo Studio. I can flash original devboards...
Dear SOC developpers,
As many kickstarters i bought an RFDUINO kit, then I made a cool prototype thanks to the easy Arduino compatibility. I'm now thinking of industrializing...
Is there a simple software code example how to configure an interrupt handler for a single GPIO-pin? I am using nRF51822 chip with softdevice S110 and the interrupt source...
My question a little weird. Because I am super beginner about BLE. So what I want is how to write string data. now i am looking to information about this. I cannot find it...
Hi
I'm trying to implement bonding in a device based on the S120. As counter part i've used a S110 device or an iOS device (realized with LightBlue App).
While searching...
Hi All,
I am using nRF51422 and now doing ANT+ certification test with tool v1.3.6. And i find out some problem with the received value on my display in case of following...
Hi
i am not able write my application after I flashed the SD. I am using Jlinker lite (the one that comes with the Dev kit) and the scripts from the nrf pure gcc . I modified...
Hi everyone,
Is it possible to connect 2 devices simultaneously with the nRF51822 device? As soon i connect one device, the advertisement stops.
So, for me it would be...
I've already posted my problem here. But it seems a dead thread.
devzone.nordicsemi.com/.../nrf51822-timer-problems
I ran into trouble when using the app_scheduler without...
Hi, I've been trying to use the timers on nRF51822 but I just can't get them to work in my code. When debugging (with GDB and Eclipse), the execution always stops with the...
