I'm having some trouble successfully entering ON,IDLE mode. I have pared-down my application to do the following:
Initializes the app_timer using the scheduler:
...
I want to control GPIO toggle by PPI. Timer1 is in timer mode. CC[0] is 1000, and CC[1] is 8000.
I use compare[0] to toggle gpio18 by PPI. I also want to use compare[1] to...
Hi,
I use two evk board to connected and test the uart serialization sample(ble_s110_serialization), one is ble_app_hrs and one is ble_app_connectivity. But I have one...
I am getting get BLE_EVT_USER_MEM_REQUEST and BLE_GAP_EVT_CONN_PARAM_UPDATE event, when writing to ble device, sample code did not handle these event, and seems no document...
Hello:
Why do I erase SDK5.2 version of flash and read not, in SDK4.2 can. I tested nrf51_sdk_v5_2_0_39364\nrf51822\Board\nrf6310\flashwrite_example is a good example.However...
before i write the flash, it has been erased.so ,its value is all 0xff.
when i write 0x00 to flash address 0x0001,the value read out is not 0x00 but 0x01,and the value in...
I'm using the 8.0 SDK and an iPad with iOS8.3. I'm experiencing the same issue described here:
pairing cancel cause reset
I've written my own service, however, I can...
Hello,
I noticed the various examples as well as the ble_advertising component all check for pending flash operations and will not start advertising until they are all...
Hi,
I am busy writing my own softdevice, this has nothing to do with bleutooth or anything like this.
In the past i didn't have to worry about the CLENR0 register because...
Hi everybody,
I have a mistake with my makefile on windows 7 platform and Eclipse C edition.
The error is quite rapid =>
20:42:38 **** Build of configuration Default...
Hello devzone...
My setup: nRF51422 and S110 peripheral
My setup transmits IR data on reception of Bluetooth data from a central device. I have used PWM for generating IR...
Does the nRF51422 ANT Inclusion/Exclusion list require all values in the list to be defined, or may some of them be '0' or 'wildcard' values?
Asked in another way, does...
Hi every one,
First of all, i'd like to thank everyone for their support and assist
I try to use the internal ADC of nrf51822 module and send the value over bluetooth...
Hi,
Is there a sample which explains about how to store some user data or do some data logging on to flash of a central device.
I tried to do it, but since device manager...
I added a registration to the pstorage module of the multilink peripheral example. However, upon calling dm_init() I get error code 7, invalid param. I checked the documentation...
I recently bought a nrf51DK. It comes with 5 sample pieces of the nrf51422 IC.
My question would be how to program this since the IC on the dev kit is not changeable? Or...
I am trying to understand the operation between BLE device & android application...
After "CONNECT_REQ", I can see several "SERVICE PROFILES" but I can't find those UUID...
Hi, I'm using the nRF8001 in an application that requires security so bonds to the remote client/central. My device supports firmware upgrades that may involve new nRF8001...
