Hello,
I have tried twice to request for SUPL license for getting A-GPS working but it has been denied both of the times. I think first time it got denied due to mismatch...
Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
Now I am using nrf51822 with PCA10004 EK board. And the custom board we are using is BL600-SA module. As BL600 can be used with nrf SDK and softdevice, Can I use...
I have a Bluetooth LE dongle and I have also a BLE device that I want to communicate with.
On the BLE device there are a several services like Cycle Power (0x1818) and Device...
I'm using the Ulink-ME tool in order to program/debug my custom board based on the nRF51822 device. The problem I have is that sometimes the flashing procedure is working...
Hi,
I do some function base on the ble_app_uart peoject and using the S130.Now I want the device disconnect the connection once it receives the disconnection command from...
We are looking into upgrading to the newer nrf52 SoCs from the current nrf51s. From the looks of it, the SoftDevice S132 is still in the alpha stage of design and validation...
Hello,
I am using SDK 9.0 and softdevice 8.0 and testing on Evaluation board.
I referred the i2c example driver suggested by Torbjorn in this link
I wrote a simple...
Hi,
Are there any plans to release the nRF51822 sniffer source ? I can only see ihex binaries in search results. I am developing some dev boards using nRF51822 xxAC and...
Hi,
I've read through several posts on this excellent forum for nRF51 on audio.
But, I have the new nRF52 Dev Kit and would like to use an analog signal from a microphone...
Hi Gentlemen,
i want to pair my mobile(central) with peripheral device by entering passkey
note: No input or display on peripheral device
suggest the method with sample...
I use 51822 HW TWI to become master.when i send the first byte(Address+write or read bit) to sensor,the event TWI-ERROR is set.Who can tell me, what is the cause of this event...
hi:
now.i have a development board(nrfgo motherboard).there is a debug port on the board.i think it can be debugged on the keil.if it can.what driver or others i need.thank...
Hello everyone,
Please forgive my continued naive questions. This is my first embedded-systems project.
I have been working with an nRF52 development board and SDK 0...
I've used the very well written IOT examples with no problem on a R PI, Ubuntu PC, and BBB all with 3.18 or 3.19 kernels. I've moved to 4.1 and 4.2 kernels and the behavior...
