Hi to all Nordic product lovers,
This is not a question but rather an announcement of a new nRF52840 based finger tip size module 14 x 9 x 1.6mm launched at CrowdSupply...
Hi,
I have a SPI slave device which outputs 8-bit registers that I have to assemble. For example, I receive two 8-bit registers, a high and a low register, which I have...
I have a PCA10059 dongle. I have inadvertently configured pin P0.25 as the sleep debug pin and I use active state 0 as I am using off board LEDs with reverse logic. This means...
If you're working on a product that requires you to show and translate GATT Attribute (Service, Characteristic and/or Descriptor) UUIDs to Strings to the user, it's likely...
Hello,
We have been trying the sendNotification call and after getting a success log we are not able to send a second notification. I'll copy the snippet of code that we...
I have a firmware developed on the nrf52840 development board. When porting it to nrf9160, a lot of errors were reported. How can I use the LOG output function on nrf9160...
Hello,
I am trying to develop a driver for the temperature ADC controller ADS124S08 https://www.ti.com/product/ADS124S08 .
I have modified the EVM to work with an external...
I'm working on the nrf5340 with a modified sample found here ( main.c of the base sample here ) and nrf connect sdk 1.7.1
I see that adc_sequence_options .interval_us can...
I need to calculate the power consumption of a device. For this I purchased PPK2.
I use nRF52-DK for tests (there is the same microcontroller as we need).
The accelerometer...
Hi,
I am trying to utilise the available thread examples to build comms from CoAP server to external website through Border Router.
I have configured Border Router as...
Hi There,
I am presently running a BLE peripheral example on a custom board with SD Card data logging functionality, The SD Card library has worked fine until now , Since...
How to print a float value in segger embedded studio?
I am using nrf5_sdk17.1.0 version
I have used the below statement but it is outputting 0 only always.
NRF_LOG_INFO...
Hi,
I am using nrf52832 for a battery powered PIR sensor. I want the device to be awake only when in it detects motion. Can anyone guide me to use the lpn example in the...
I am using nRF52840 SoC for NCP/RCP application at the border router side, and nRF_Connect_SDK_v1.9.1 for NCP/RCP application development. My border router is my custom gateway...
Hey!
I want to try my SIM but I can't start the modem. Each command related to the modem that I execute gives me this error. I tried different firmware, but I can't upload...
I am looking for a BLE module to develop a product which will be used to track location and speed, with at least 2Hz frequency.
Requirements:
- Precision (location must...
Hello,
I would like to use the nRF5340 DK external debug port to program Thingy:91 as shown in Thingy:91's Getting started guide.
I believe that it is possible to use...
Hi
I want to use Sqrt() function from math.h but in my application it triggers some errors. Kindly guide me on how to properly include the math.h library into my application...
Dear Mr, Mrs
I was wondering how many flash size is left to the application firmware for a nrf52810 using both central & peripheral.
As far as I undestood, I need a s132...
Hi! I'm working on this particular project and the next step that I need to solve is connected to find a way to put in the same application the code of the GNSS example and...
