Hi to all Nordic product lovers,
This is not a question but rather an announcement of a new nRF52840 based finger tip size module 14 x 9 x 1.6mm launched at CrowdSupply...
Hi,
I have a SPI slave device which outputs 8-bit registers that I have to assemble. For example, I receive two 8-bit registers, a high and a low register, which I have...
I have a PCA10059 dongle. I have inadvertently configured pin P0.25 as the sleep debug pin and I use active state 0 as I am using off board LEDs with reverse logic. This means...
If you're working on a product that requires you to show and translate GATT Attribute (Service, Characteristic and/or Descriptor) UUIDs to Strings to the user, it's likely...
Hello,
We have been trying the sendNotification call and after getting a success log we are not able to send a second notification. I'll copy the snippet of code that we...
I have a firmware developed on the nrf52840 development board. When porting it to nrf9160, a lot of errors were reported. How can I use the LOG output function on nrf9160...
Hi
Evaluating nRF5340 and 52833 devices for our product prototype. Besides of BT functions we need to support certain real-time hardware capabilities such as very narrow...
Hi, we're just starting with BLE and Mesh. Very confusing and find it hard to follow the on line information. Hopefully someone can point us in the right direction :
My...
I posted a similar question yesterday for an example using the standard SDK. The fix was to make the flag set by the event handler andI used for the IF statement in my main...
Hello,
I am reading a data from a file and sending write req in loop to transfer chunk of data using pc_ble_driver but getting following error message after transferring...
I am trying to re-connect my android phone to nrf51822 using already existing bond, I am able to reconnect to the card, but the issue is I still need to perform gatt.discoverServices...
This was already discussed in several threads but seems to be still unsolved completely. We have some android devices and ios devices. The peripheral is encrypted with LESC...
I have modified the ble peripheral example - ble_app_uart to run on the PCA10059 USB dongle and the demo I developed using that as a starting point works very well. The problem...
Hi Team,
I am developing a product that is a combination of a mobile app and a hardware including an nRF52832. The hardware should notify the mobile app on events as quickly...
Hi,
I would like a circuit recommendation with LNA to connect an external passive gps antenna? Is it possible to use an external passive antenna with nRF9160 or is it more...
Trying to read the device identifier register on network core returns all ones -
Curious why this is so? Other INFO registers have seemingly valid values
Hi,
we try to get the NRF52840 to sleep and then wake up from an GPIO interrupt.
We try it in debug mode which should give a emulated sleep mode. So we stop all processing...
Hi,
I would like to enable the APPROTECT readback protection.
What is the advised way to do this when using nrf connect/zephyr? The following line doesn't work (the 'at...
Hi everyone, I'm new to DevZone.
I am writing to ask for info for the first application with BLE.
I need to send data acquired by sensors, RAW mode, via the BLE application...
