Hi,
I have a SPI slave device which outputs 8-bit registers that I have to assemble. For example, I receive two 8-bit registers, a high and a low register, which I have...
I have a PCA10059 dongle. I have inadvertently configured pin P0.25 as the sleep debug pin and I use active state 0 as I am using off board LEDs with reverse logic. This means...
If you're working on a product that requires you to show and translate GATT Attribute (Service, Characteristic and/or Descriptor) UUIDs to Strings to the user, it's likely...
Hello,
We have been trying the sendNotification call and after getting a success log we are not able to send a second notification. I'll copy the snippet of code that we...
I have a firmware developed on the nrf52840 development board. When porting it to nrf9160, a lot of errors were reported. How can I use the LOG output function on nrf9160...
Hi I would like to ask you for advice on how to solve my problem with Ble and the timer I am trying to add a timer to examples\ble_peripheral\ble_app_uart the timer works...
Hello everyone,
I have following problem. I am trying to build a mesh network with the nRF52840 DK and the nRF52840 Dongle.
I am using the "nRF5 SDK for Mesh" (V4.2.0...
Dear Team,
Greetings,
I am facing a problem for configuring Port 1 as input. I have connected a push button on P1.4 and an led on P0.0. I want to perform a simple task...
There is a similar question here , but it uses a custom makefile which I am not familiar with. I am trying to convert a program I wrote using base TWI communication to use...
I had a custom BLE service working just fine, but once I tried to integrate buttonless DFU (based on the SDK example) I started getting the NRF_ERROR_NO_MEM error. I was able...
Hi. I am using three different device which can communicate with the nRF52840 through SPI.
I am using nRF52840 as master and the three device as slave. All the device will...
Hello,
This is regarding the problem faced while flash and debug the nrf9160 feather,
1) Build and flash using the west
we are using nrf 9160 feather so it has...
Hi
Is there a possibility to have an individual pinreset time? In my product the default reset time from 20ms is not enough.
Can you extend the command with a time parameter...
When I enable the OTA AT Command on the nRF52832 module and click on the DFU option available on the nRF toolbox Android Application, selected the OTA Package which shows...
Hello,
I am working with the nrf52840 chip and wanted to know if there are any pins that are shown on the schematic diagram, that I should not use to ensure that the Bluetooth...
I am working with nRFConnect and the nRF91-DK on MacOS Catalina.
After updating the command line tools I was able to program using the GUI
But now I want to write this...
