Hi,
I have a SPI slave device which outputs 8-bit registers that I have to assemble. For example, I receive two 8-bit registers, a high and a low register, which I have...
I have a PCA10059 dongle. I have inadvertently configured pin P0.25 as the sleep debug pin and I use active state 0 as I am using off board LEDs with reverse logic. This means...
If you're working on a product that requires you to show and translate GATT Attribute (Service, Characteristic and/or Descriptor) UUIDs to Strings to the user, it's likely...
Hello,
We have been trying the sendNotification call and after getting a success log we are not able to send a second notification. I'll copy the snippet of code that we...
I have a firmware developed on the nrf52840 development board. When porting it to nrf9160, a lot of errors were reported. How can I use the LOG output function on nrf9160...
Hi I would like to ask you for advice on how to solve my problem with Ble and the timer I am trying to add a timer to examples\ble_peripheral\ble_app_uart the timer works...
So im trying to interact with a nrf52 chip. I am using iOS corebluetooth to communicate with the device and when the device sends a long data packet (~400 bytes) iOS drops...
Hi,
I have my SAADC configured with two channels. One for my sensor and one for the battery level measurement.
I only need to measure my battery level every minute for...
hi,i have a question.
nRF52832,can not Pairing and binding.SDK13.0.0,base onble_app_hids_keyboard example.
It can be paired and bounded before. but now can't pair and...
Hello,
SDK 15.2.0
SoftDevice 6.1.0
DFU with Uart (based on {SDK}\examples\dfu\secure_bootloader\pca10040_uart. Single bank mode as my app is quite big (probably not...
Hi,
I am using Segger Embedded Studio and SDK version 15.2 for NRF52840 based module. NRF_LOG_INFO() works from main.c but not from custom drivers for sensors. Is there...
I have two of the nrf52840 boards and want one to implement a cascade reconciliation between them. That is device A and B have similar secret keys but need to make them match...
Dear nordic,
I tested simple coap thread examples. it's work fine. I want to know some details regarding this.
1. Is it possible to find IP address of all node in one...
Hi.
I am using NRF51822 and SDK is 12.3.0. I know that NRF51822 has random delay(0ms~10ms).
However, there must be no delay to complete the development of the board...
Hello!
I am a master student at NTNU Trondheim working on modelling the energy consumption of NB-IoT for IoT application simulations in cooperation with the NTNU IME IoT...
Hi Team,
I am new to nrf and using Nrf52832 and SDK 14.2.0 for development I am facing a problem, I want to select only Port0 pins as GPIO pins. how to make it. I gone through...
I use the following settings to communicate with the nRF24L. But there is no connection. What's wrong? NRF_RADIO->TXPOWER = (RADIO_TXPOWER_TXPOWER_0dBm << RADIO_TXPOWER_TXPOWER_Pos...
Hi, i'm starting to develop on the nrf52840DK and trying to understand the Nordic SDK (using the lastest version at the time 15.3). Just edited the blinky example to read...
Hi,
I am developing a product using nRF2840 which performs periodic sensor readings.
Due to the nature of the sensor I'm reading from ( sensitive to noises and placement...
