Hi,
We are using the nrfconnect for thread and zigbee 3.2.
We have modelled our Bluetooth peripheral, running on the nrf52840, on the BLE UART example. It connects fine...
I have installed nrf-command-line-tools_10.24.2_amd64 and jLink_Linux_V794e_x86_64 on Ubuntu 22.04. I have also installed nrfconnect-5.0.2-x86_64 for desktop and the Toolchain...
Hello,
We have an NCS v2.2.0 nRF5340 application with MCUboot that requires GPIO control of a few pins extremely early in the startup process. We have a signal "A" pulled...
Hello,
Our product uses nRF52840 and roughly 2 of 1000 has problem with 32MHz crystal.
- Firmware always stuck at following code: (when USB connector is plugged) ...
I've been attempting to use the FOTA module to download application updates. We are using AWS and generating URLs on the fly that are received via MQTT messages. The URLs...
Hi,
I use nRF5340 DK SDK 2.2.0. as Central and multiple iPhones as Peripheral.
I have a question about concurrent (simultaneous) BLE connections.
1. is it possible with...
I want to setup VS Code.
But I couldn't choose a nRF Connect SDK:
And there is also an error message:
"Invalid nRF Connect SDK. Valid SDK folders contain either an...
Hello, We are using nRF9160 for asset tracking product. We used nRF52832 as an BLE+MCU. I have some queries regarding the schematic design of nRF9160. 1. Is it mandatory to...
Hello,
I am new to nRF52 and i'm now working on the nRF52810. what i want to know is what are the SoftDevices that are compatible to the nRF52810, and what is the SoftDevice...
I'm referencing the post where the calculation for custom baudrates are given by an nordic support engineer.
Currently we are trying to merge custom baudrate support to...
Hi Folks,
I have a question regarding long range and an observed poor communication link with some packet lost.
Does the errata 191, linked here could provide an explanation...
Hi,
We are using the API from dfu_target_mcuboot.c to perform DFU on NRF52840.
We set the following flags in prj.conf.
After finishing the call of "dfu_target_mcuboot_set_buf...
Erase, read with XIP: 1. erase and then read, do I need to call the function to enable XIP? 2. after writing data, use XIP to read immediately, can you read the data, or will...
Hello,
I'm developing a software on a nRF9160 board.
Then I need to know where am I, the nRF9160 location of timezone or localtime.
I tried AT%XTIME modem command...
Hello all,
Quick question, why is BLE LESC missing from the set_security_req function in ble_srv_common.
I did see a devzone post from 4 years ago, where bjorn-spockeli...
The battery service failed by Bluetooth BQB certification,
NRF52832 with nRF5_SDK_17.0.2 keil V5.27
My config as below:
static void bas_init(void) { ret_code_t err_code;...