Hi,
We are using the nrfconnect for thread and zigbee 3.2.
We have modelled our Bluetooth peripheral, running on the nrf52840, on the BLE UART example. It connects fine...
I have installed nrf-command-line-tools_10.24.2_amd64 and jLink_Linux_V794e_x86_64 on Ubuntu 22.04. I have also installed nrfconnect-5.0.2-x86_64 for desktop and the Toolchain...
Hello,
We have an NCS v2.2.0 nRF5340 application with MCUboot that requires GPIO control of a few pins extremely early in the startup process. We have a signal "A" pulled...
We are looking for an experienced software developer, for existing board with using nRF Connect SDK. We are using nRF52840-dk.
Please, contact me if you are interested.
I use 52840 to make a HID device. Sometimes the data has been sent out during the data transfer. The USB sniffer also monitors that the data of the USB IN has been sent out...
This might be the most trivial question in the whole QA history. But I have to ask and hope I can get the answer.
Because chatGPT told me, `lc` is `mostly likely` stands...
Hello, I'm trying to set up the DFU over the air mesh. Using the mesh SDK 5 and nRF SDK 7.1.0.
Using the DFU example from nrf sdk17.1.0, I successfully ran it.
When I...
We are currently experiencing a strange BLE Disconnect issue that I haven't been manage to sort out for a long time now.
We have a device that acts as a peripheral that...
Hi, we are using the LPUART in async mode to communicate between an nRF52840 and an nRF9160. Everything works well except when a timeout occurs. I noticed this when the other...
Hi,
1. Which part of the radio laws and regulations shall I be responsible for when the Bluetooth transmitting power is less than 10dBm?
2. Which part of the radio laws...
Dear Support Team
I am preparing to develop a Thread application which have one node was used to receive data from all other nodes in the same Thread network. I found that...
Hi,
I am working with nrf52832 dk . I use cental_multilink example code. I want to get data of first connected device when secont connetion is disconnecting. Currently first...
We are running the SLM application (build with native TLS overlay) on the nRF9160 DK with modem firmware version mfw_nrf9160_1.3.1.
Please take notice I tried the HTTPS...
Hi there, I am trying to access a TWI device using the TWIM driver.
I have done the following in sdk_config.h:
and included these files:
nrfx_twi.c, nrfx_twim.c, nrf_drv_twi...
Hello, I am using the 52805 in a product and have achieved low power successfully.
I have a final requirement that I am trying to solve and want to know if there is an event...
Hello,
I am able to successfully provision and configure all the nodes in the network using the provisioner example(provisioner node is another nrf52840) over the standard...
Hello !
Do you have more information about partial radio driver framework under CONFIG_NET_L2_CUSTOM_IEEE802154 ?
I need to write custom radio driver and would like to...
The code in dm.c uses nrf_dm_calc() to calculate the distance
I wanted to try using nrf_dm_high_precision_calc() function to see if accuracy improves so I added the following...