Hi there,
This is a follow up post from my earlier one here about using nRF5340 dk as an I2S master for the purpose of recording sound using a MEMS sensor ICS43434. Here...
Hello DevZone!
All samples with Application Event Manager (CAF, nRF Desktop) has simple main function like that:
Main thread has terminated after executing and main...
Hi all,
I'm working on a Nordic-based system involving multiple nRF52-series chips exchanging high-rate sensor data over both radio and SPI links. The setup involves two...
I'm working on a custom board that uses an nRF52832 module. It has a single button that is used to power the device On/Off and a >= 5sec long press from Off to force enter...
Hello,
we would like to use a pin on GPIO P1 as GPIO in non-secure mode, but only found the solution stated in this thread yet: https://devzone.nordicsemi.com/f/nordic-q...
Hello,
I am experiencing issues with an nRF5340 board and its SPI.
I am trying to add an Pmod OLED (128x32) screen to my board, but firstly I am trying to set up the...
Zephyr nRF52840
I am working with 2 nRF52840dk. The master side seems to be working as expected. i have monitored it and seen clock, MOSI and CS all working as expected...
Hello,
I have a debugging issue with VS code IDE.
Suddenly, i cant debug with an error:
However, flashing board is working succesfully.
What am i supposed to do...
We use spi flash with custom driver and goal is to set it to act as secondary partition for MCUBoot.
The question is how to adapt driver to be accepted by MCUBoot, maybe...
Hello,
First off, thank you for reading this. I know this is on the cutting edge, so bugs are to be expected.
Problem:
I loaded the dm sample found here: https://developer...
Hi,
I am using nCS and mcuboot in my application for development, on nRF52833.
I build a nCS project, the build bin file (prj.conf as ):
I broke up into packets...
Hi. I am trying to use Free RTOS in my code and from the example blinky free rtos I am recreating the code. I have added the path and library files. But when I try to compile...
Hi All,
I was trying to upload the latest revision of some code i wish to verify before pushing to production and was using the command line to generate the bootloader...
I have a simple blinky application. I was able to get the application running and using the Qzone debugger. When I change the application te be a MCUboot compatible application...
Hello,
I just noticed something odd. When I just the hex file have provided with me
It worked perfectly, however, when I try to flash the lte_ble_gateway sample program...
Hi Nordic Support,
I'm getting this error while trying to connect two 52840 DK, one programmed with the connectivity firmware, and the other one with a sort of ble cli...
