Hello, Have some experience with embedded development, but new to nRF Connect, sysbuild, Kconfig etc.
Using Windows host VS code with nRF Connect extensions - current versions...
HI,
I am using the nrf_desktop sample in NCS V3.0.2, I want to buil with prj_release_dongle.conf , the setting
but build fail, I check the file Path: it should be F...
Hi, having some issues with the matter door lock sample for the nRF54L15DK on NCS 3.0.2. I'm getting strange failures on boot when running the default matter door lock sample...
Hi:
I'm doing exercise 1 of lesson 1 of the nRF Connect SDK Intermediate course. It says: Get the source code of this course as a third-party repository within the SDK itself...
Hi, On the nrf54L15 with MCU boot enabled, what is approximately the fastest time that the chip could boot and set a gpio line high, if everything not critical is disabled...
Hello,
At the moment we are at a point to decide, if we want to expose our loads of data in “parallel” over BLE characteristics or if we should better implement a serial...
I am trying to update voltage level in Major value of my beacon. Using nrf_drv_saadc_sample() I have called saadc_event_handler(). The event triggered for first call but not...
HI, I am trying to compile the thingy52 firmware in segger embedded studio 4.10a by following the below link,
http://infocenter.nordicsemi.com/index.jsp?topic=%2Fcom.nordic...
Using sdk12.3 on pca10040.
I wanted to test persistence so I modified the example from the SDK as follows: log what's already there. don't erase. enter new data. log it...
Hello,
I'm wondering why isn't the nRF5 SDK on GitHub yet. There have been many instances where I have found bugs or missing features in the SDK, that I have implemented...
Hi,
I'm developing an application with SDK 15 that requires multiple concurrent links. One peripheral link and several central links.
I want the peripheral link to have...
I am new to nRF,
Unable to read data using flash data storage example.
When ever i try to read it
throughs error and processor enters into error handler and hangs there...
Default startup:
Using ble_multi_lesc as my default project
Log of original connection is in attached logLOTest.txt file
Currently only 1 nrfConnect is connected and...
hiii......
i am using nrf52832 interfacing with temperature sensor using temperature sensor example program..15.2v
i want to read the temperature ..... my temperature...
I have an application where I'd like to change the advertising content every time it is transmitted. Is there any callback from the SD after transmission of advertising data...
Hello. In my application I am using nRF5 SDK 15.2.0 9412b96. I am trying to communicate with two devices on two different SPIM instances. The first device is a DW1000 radio...
Dear Sir:
We observed that everytime we use OTA to update the firmware of the nRF52, the 6Byte address will change, just minus 1 compared with before, such as
FC:AE:3F...
I am using the software PWM library (SDK12.0) with the DRV8834 to drive a bipolar stepper motor. Although the motor is working in both directions with the code below, the...
Hi, I want to make sure that all application data are erased when we do a DFU, so that the newer application get a clean start without having to worry about data from older...
