Hi Nordic,
I am currently writing about the process of performing channel sounding sequentially on three connected devices. However, after the first channel sounding is...
I am using LVGL for simple Eink display UI, and trying to implement a simple if condition to check if the passed string argument is null as below:
If I only have btn1...
Nordic TS,
I've installed and begin to experiment with the DECT NR+ v1.1.1.0 FW. Initially, I'm noticing on obvious difference in the behavior of the dect_hello sample between...
I am trying to use the FIFO from the ADXL362 with in the Thingy:53. As I noticed there is now the Option to use ADXL362_STREAM. I just wanted to use the example from: https...
The specification for the nRF54L15 states that the typical current consumption for I_TIMER3 (TIMER10 running) is 240 mA/milliamps . The other timer values in the table are...
The Nordic Thingy:91X was initially unable to connect using certain SIMs (e.g., Airtel IoT) due to lack of NB-IoT support or no signal.
After switching to a Jio NB-IoT...
Hi to all,
I am trying to do a ZUTH (Zigbee unified test harness) test run, using the Silabs devices as golden devices (as per CSA recommendation) and nRF 52840 dongles...
Hi,
I know that the default handle value of device name is 3, but in my application i am not getting the default device name handle, is it possible to change the device...
I want to save precious CPU cycles by writing 40 i2c (TWI) registers in one shot. Can I somehow set up the TWI master to write 40 registers (each 16-byte address with 8-bit...
What is the maximum length of pdu for ble advertisement? I have ported the example application of solar powered beacon without softdevice.
I just wanted to know if it was...
For what I understand of the doc and this question it is possible to turn off the SD, turn it on later and then use the settings as normal.
Is it possible to turn on the...
Using nRF52; S132 v4.0.3
I'm getting NRF_ERROR_DATA_SIZE error return from sd_ble_evt_get and event length from call is 20 which is smaller than my buffer so it shouldn...
Hello everyone,
Currently we're writing a small program for the NRF52 (PCA10040), which has to communicate via SPI to an IMU (MPU-9250). The code is working correctly,...
Hi,
I am using SDK 11 , nRF52 DK . IAR 7.5
In current implementation I am flashing a sofdevice s132 and the bootloader by the nrfjprog.exe but if I am flashing the app this...
NRF52832 S132 MPU6050 TWI
I want to finish the function:
1. When the ACC, GYRO data update, the INT pin to generate an interrupt, and then in the P026 pin configuration...
hi team,
i need to receive data via uart0 without uart_irq handler. i am using simple_uart .h library. please any one reply me...
need urgently...
thanks advance
hello,
I am using nrf52 dk. I am doing a project that uart send the adc data through bluetooth to nRF UART v2.0 app for every 10msec. but when i am transmitting the data...
I'm sure the same question has been asked in a few different forms, but hoping for some ideas. . .
Is there a way to retain 32 bits of information across a watchdog reset...
