Hi,
I am using "asset tracker" project in nRF9160 DK.
I want to update asset tracker application through HTTP.
So i migrated changes of "asset tacker" in main function...
I have a simple TCP client application running on the nRF9160. After connection to the server, recv is called and writes the data over Segger RTT channel 1, where on the host...
Hi,
firstly, I have to say, I use MBED OS, if you cannot help me because of this, I understand, but maybe somebody still has some general Ideas.
I am trying to build an...
Hi everyone,
Currently, I am working on my bachelor thesis for creating simple network by using MQTT, BLE-6LoWPAN and nRF52832. I have three nodes of 52832 and one raspberry...
Hello everyone!
I want to form an Openthread network with three Nordic nRF52840 cardboards. I would like to monitor the traffic using a sniffer, but i can't receive any...
We are using the development board PCA10040 for implementing a prototype with several GPIO interruptions.
We are trying to use the NFC pins (pin 9 and 10) as pins of GPIO...
In 15.3, there is a new application type valid for DFU, external app. When loaded through DFU, the program just sits there in bank1, and doesn't get sent anywhere. I'd like...
Hi, I'm trying to use the iOS nRF Mesh Library on GitHub: https://github.com/NordicSemiconductor/IOS-nRF-Mesh-Library
I've managed to install the iOS app, but I am unsure...
Hello,
I'm attempting to connect the nRF9160 DK to our AWS IoT account. I've been following the information in this question: https://devzone.nordicsemi.com/f/nordic-q-a...
Hi, looking for some advice regarding hardfault analysis. Using NRF52840 with SDK 15.3 and SD 6.1.0, i am seeing occasional hard fault (after ~30 min to 2 hours), during relatively...
Hi,
I know it is a silly question but I would like to ask does nRF52810 support SPI, TWI, UARTE etc.
Below is block diagram from datasheet of nRF52810 which shows it has...
Hello,
I was able to flash demo .hex to my nRF52840DKs from this ( https://github.com/NordicPlayground/nrf52-ble-multi-link-multi-role ) project, but now I would like to...
I alway used direct UART command with nRF24AP2 and CW test was not a problem.
Now with nRF52xxx and S212 softdevice I try this ... but nothing works .
sd_ant_stack_reset...
I've used Segger Embedded Studio to compile and run a number of example projects -- nicely done!
Now I'm ready to start creating my own projects, with the ultimate goal...
hello,
i'm trying to communicate between a central device and a peripheral.so if multiple peripherals are present and all of their mac id is known.how can i select a particular...
SDK 14.2
i just added peer manager to an existing project, and peer manager seems to be working correctly. pm_peer_data_app_data_store() is successfully called to save addition...
Hi!
I'm currently in the process of evaluating the nRF9160 DK. I'm trying to measure the current of the LTE when the PSM mode it's set. I'm using the at_client application...
Hi team,
My customer found that our SDK15.3 is supporting FreeRTOS version 10, but their original codes are based on FreeRTOS version 9, do we have any guideline which version...
