Hi. I'm using nRF52832, SDK13.0.0.
I should use SHA256 and MD5.
I made my code as below.
NRF_CRYPTO_HASH_CREATE(init_packet_hash, SHA256); NRF_CRYPTO_HASH_CREATE(init_packet_md5...
Hi. I'm using nRF52832, SDK13.0.0.
I want to use SHA256 as below.
output32Byte = SHA256[input32Byte];
Which function or example can I refer to?
And also I want to...
I tried to port the example "ble_app_ipsp_initiator" to pc-ble-driver and run on Linux. The peer device is another PCA10056 device running ble_app_ipsp_acceptor. The problem...
hi...
i want to use two uarts in nRF52840 , one uart to one pc and another uart to another pc .Data should be transferred and received between the nRF52840 and pc how can...
Hi, i'm using two nrf52840 DK ev kit. One it's the central and one the peripheral
After the connection I need to save power at the peripheral board, because the cpnsumptio...
In mesh example project “dimming_server”，I have added functions: mesh serial, SAADC(use ppi) and compie pass.However,when debugging,an error is happened in the function"nrf_drv_timer_init...
NRF52840 support the long range bluetooth and BLE gateway SDK, look at here that RAK Wireless held a Beta and welcome the community to participate.This board with Cellular...
Hi all , when I combine light switch server and remote server in 1 Node and use Provisioner Node for provisioning and config for it . I have error
Log in provisioner : ...
Hi,
I have to transfer messages every 100ms and to receive confirmation about successfull reception.
Message is sent from the phone and should make two hoos and return...
Hello,
I'm using the PWM peripheral to generate a waveform. The waveform is loaded into RAM and then I use the SEQ[n].PTR and SEQ[n].CNT registers to set up the DMA. The...
Hi to all,
i am working on a project based on nrf51822 soc, i want measure level of battery with nrf51822 ADC channel.
i have an example code that measure the level of...
Hi all,
I can't get the Blinky example working on my PCA10040 kit. After flashing, LED1 stays on and there is some activity on LD5 but the kit is not detected on all my...
Hello,
I'm currently developing an application using an NRF52832 and SDK15 (SD 6.0.0). I have an issue that causes an UART overrun during some flash operations and it somehow...
I was wondering if it was any use to make use of gains 2 and 4, and noticed the errors for those gains are missing in the PS.
So do gains 2 and 4 actually increase the resolution...
i want to sinchronyze diferent peripheral and 1 central thank's to the gpiote's state.
but i have a error 8 invalid state whereas i had initialize
help me please !!! ...
I am using nordic nrf52840 sdk kit as a peripheral and mi 5A mobile as a central .The problem is continuously disconnecting with following reason
Reason: Remote User Terminated...
I am trying to read values from an analog peripheral device. To perform an analog read, I am using this example from the NordicSnippets simple examples:
https://github.com...
Hi, I have been trying this for 3 days.
I was using DBGX_EVTX in SR3v1.1 to check the log, it works fine and never goes wrong.
But in v1.2, is using another function instead...
Hello everybody,
I am using central device with SDK14.2 and S132.
In a central application, the operation sequence is as follows: * Buttons pressed and scan started *...
