Hello,
We are looking for a developer a single task project. We need to provide all of our developers with the same development environment, so we are looking for someone...
I'm looking for a good firmware engineer that can take my current firmware and add the buttonless DFU to it. I currently use the Keil environment but am open to switching...
I am working on PCA10040 board using Keil u5 debugger (V5.23.0.0, JLink setup). After accepting the continuous firmware update requests I get the error message "Missing core...
Hi,
I have just started using a nRF52840 PDK board with the purpose to verify BT 5.0 features. I am completely beginner working with nRF boards or nRF SDK. Anyways, I downloaded...
I have a USB host capable Android device running CentOS via Linux Deploy and everything is working perfectly except i'm unable to connect to my USB nRF24LU1+ Crazyradio PA...
Hi,
I am using multiperipheral mode in ble_app_hrs using the ble_app_multiperipheral example taking the functions on_connected and on_disconnected while connect and disconnect...
Hi,
I’m running the SDK 17, S132 and I do have the PC10040 board.
My embedded bluetooth application will work as a BLE UART, I will send and receive small blocks of data...
Now I use nrf52810 to develop a device, and now I want to use SD_ power_ system_ Off (); turn off the device, and now turn on the device again. What can I do to achieve this...
In the instructions for setting up a project in Segger Embedded Studio it states...
Select File > Open nRF Connect SDK Project .
To import a project into SES, you must...
Hello,
I encountered a problem. When I turn off app_timer during timeslot interruption, it cannot generate app_timer interrupt code show as below:
I am using app_timer2...
I have an application which is currently using a the custom RADIO_MODE_MODE_Nrf_250Kbit mode, and I want to port it to the 52840 and 52911 using
RADIO_MODE_MODE_Ble_LR125Kbit...
To the kind attention of Nordic support team,
I'm very interested in understanding how to have firmware that is working as in PCA10059 in respect to USB bootloader and fw...
hi everyone
I'm new for mesh. having read the document,but have some question.
1 Could the mesh DFU bootloader update the source devices' application through its serial...
Dear all and Nordic Staff:
Thanks for your support as usual.
I have a new application project with BLE and Zigbee dual stack protocol for industry market.
May you suggest...
One of the nRF52840-DK (PCA10056 v2.0.0) we are using as a programmer and debugger for our custom board has started repeatedly resetting the custom board whenever an RTT console...
ble_gatt_db.h and ble_db_discovery.h each contain #defines that are problematic, BLE_GATT_DB_MAX_CHARS and BLE_DB_DISCOVERY_MAX_SRV respectively.
Of course, one can change...
We use NRF52832 in the remote control of the car。 We measured the average current of power consumption at about 1uA.Every 300ms, the current curve bounces to the transient...
I would like to use the RTC in the nRF52833 as a clock-calendar. The device will normally be powered by the USB Vbus but must have power fail protection to insure the integrity...
