Hi,
I'm interfacing a nrf51822 and a H8/3294. My question is how much can I drain a the txd pin of the H8/3294. That means my question isn't really about nrf51822.
In documentation...
Hi,
On the 3.30 of nRF52832_Rev_1_Errata_v1.5.pdf, the sleep current with LFXO active is 0.5μA higher.
I am using a nRF52832 module with the low frequency crystal oscillator...
Hi,
I'm using nRF52832 on SDK V12.2. I add the connection params in the conn_params_init:
static void conn_params_init(void){
uint32_t err_code;
ble_conn_params_init_t...
S130, SDK 12.3, ble_app_hrs_c example.
I want to use whitelist function in this example but I can't finish it.
When I run peer_list_get(), it gets all 0xFF, means that...
Hi all,
I am making a device which involves using nfr52832(PCA10040) to communicate with a NAND flash through spi to store data acquired from the ADC. After all the data...
Hello. I am developing a project with a static password. And when I connect to the device, in the debug messages for the auth_status field I get the following values: 61,...
Hi ,
I want to add DFU service into ble_app-uart example, for that I want take reference as ble_app_buttonless_dfu.
But when I am trying to test the working of ble_app_button_less_dfu...
I developed an application based on ble_app_uart and it is working on my nRF51 DK. I can see the ports driven by my application responding and Bluetooth communication is working...
I am currently using Mesh SDK 3.1, running on NRF52480 with SoftDevice140. We are currently modifying the light switch client, and would like to know which servers are available...
Hello,
I would like to implement a device that is part of a BLE Mesh Network and on the other side connects to another device directly with BLE Stack (1:1) and GATT.
...
I am developing an android application to get real-time temperature over BLE notification. Currently, I receive the temperature sensing data 1 time per second. Based on the...
Hello,
In nrf_dfu_ble.c BLE_GAP_EVT_SEC_PARAMS_REQUEST pairing on Windows 10, the following code:
err_code = sd_ble_gatts_value_get(m_conn_handle, BLE_UUID_GATT_CHARACTERISTIC_SERVICE_CHANGED...
Hello everyone!
I want to form an Openthread network with three Nordic nRF52840 cardboards. I would like to monitor the traffic using a sniffer, but i can't receive any...
I want to implement the function of periodic temperature collection，but I didn`t find any data show in putty terminal，and I`ve set NRFX_TIMER_ENABLED 1 NRFX_TIMER0_ENABLED...
Hello,
The BLE mesh spec says the following:
Heartbeat is used to monitor nodes on a network and discover how far nodes are apart from each other.
Is there an example...
Hello. I have read a topic about ADC calibration (gain and offset error in 0x10000024) of nRF51822 here but I can't find the document describing it. Could anyone point me...
Hi,
I am beginning to design a wearable device with motor vibration using nRF52 SDK and SoftDevice S132.
In firmware side, I have no problem to control a led on and off...
Hi
in my test bench for system validation I would like to control the system based on nRF52 via Bluetooth to speed up testting of various samples.
It seems that there...
