Hi,
On the 3.30 of nRF52832_Rev_1_Errata_v1.5.pdf, the sleep current with LFXO active is 0.5μA higher.
I am using a nRF52832 module with the low frequency crystal oscillator...
Hi,
I'm using nRF52832 on SDK V12.2. I add the connection params in the conn_params_init:
static void conn_params_init(void){
uint32_t err_code;
ble_conn_params_init_t...
S130, SDK 12.3, ble_app_hrs_c example.
I want to use whitelist function in this example but I can't finish it.
When I run peer_list_get(), it gets all 0xFF, means that...
Hi all,
I am making a device which involves using nfr52832(PCA10040) to communicate with a NAND flash through spi to store data acquired from the ADC. After all the data...
How to enable semihosting in sdk11 examples?
This works, but I can't port it to examples/periferal/template_project :(
changes:
pca10028/armgcc/Makefile:
adding...
Hi all,
It's my first post here so hello everybody!
I'm quite new in BLE5, but I have been playing with BLE4 some years ago (around 12) and I want to confirm some...
Hi Nordic
When I use JLINK to burn the firmware to the nRF52832 chip in the device, some devices cannot be programmed or cannot be programmed again after burning once
...
Hello, I've stumbled about a problem with the NrfConnect extension and Kconfig. It is quite simple: When a project directory contains a Kconfig file, it is used by west as...
I'm a bit confused by the "unidirectional" solutions offered as examples / documentation for the nRF5340 DK. I would like to build a BLE Audio headset that both receives and...
Hi
How is the ESB_EVT_IRQHandler started? NVIC_SetPendingIRQ(ESB_EVT_IRQ) is registered with on_radio_disabled(), but I don't know how to be started this handler in the...
Hi:
I use ncs 1.9.1, borad nRF9160-DK
sda-pin = <30>; scl-pin = <31>;
Config:
I added i2c2 in blinky, here is the source code.
I see i2c2 enabled in...
Hello,
I am experiencing issues with an nRF5340 DK. I would like to try the matter samples but every time I flash one of them, it results in fatal error and reseting loop...
fota_download_start copies the file but not host string into a static buffer. The comment implies that the download_client only requires this for the file path, though it...
Hi everyone, i have some problems with firmware and i hope someone can help me. I am using nRF52840 microcontroller and SEGGER Embedded Studio. Also I'm using the littlefs...
Hi ,
I want to use a pin on board, which is not used or initialized in dts file . my requirement is that I want to initialize that pin before booting process. ( that pin...
Hi,
I am using the :
bt_scan_filter_add (BT_SCAN_FILTER_TYPE_MANUFACTURER_DATA, &mfgData);
scan-filter works well.
However, keeping everything same, if setting...
