During the setup process for nRF Connect SDK v2.4.0, an error occurred preventing the SDK from installing correctly.
The environment details are as follows:
* macOS...
Hi,
We are using the nrfconnect for thread and zigbee 3.2.
We have modelled our Bluetooth peripheral, running on the nrf52840, on the BLE UART example. It connects fine...
I have installed nrf-command-line-tools_10.24.2_amd64 and jLink_Linux_V794e_x86_64 on Ubuntu 22.04. I have also installed nrfconnect-5.0.2-x86_64 for desktop and the Toolchain...
Hello,
We have an NCS v2.2.0 nRF5340 application with MCUboot that requires GPIO control of a few pins extremely early in the startup process. We have a signal "A" pulled...
Hi mate,
I followed (+) Add DFU support to your application - Software - nRF Connect SDK guides - Nordic DevZone (nordicsemi.com) your instructions and successfully implemented...
We found that when testing the nRF52832 chip, if the C9 capacitor is empty, the chip broadcast power consumption increases from 20uA to 40uA, and the power consumption of...
Hello,
Over the years we've occasionally been experiencing a issue with nRF52840 and nRF52832 chips in case of which any BLE activity would stop happening. A chip mounted...
Hi,
I've used the module https://github.com/NordicSemiconductor/cloud-firmware-ci-device-helpers-js to create device certificates for a nRF9160 device and then AWS JITP...
Hi there,
Is it at all possible to run nRF Connect for Desktop apps like the programmer and the power profiler from outside the nrf connect for desktop app?
e.g. is there...
Good day,
is there a way to check if a client is connected to GATT server/service? Would like to send a data after device gets reconnected.
i am using PCA10040 with...
Hello dear Nordic. I am wondering if I can simulate a hardware event by the software by writing any value to the event register, or in other words to create artificial interrupt...
Hi,
I implement the CLI on my nRF52820 and I see in function cursor_next_line_move in file nrf_cli.c they use "\n" but for my project I don't want to pass in cursor_next_line_move...
Hello,
I'm tryng to update nRF9160sip (rev b1), I push sw4 on power on and I see "MCUBOOT" device on "Programmer v3.03"
Then I select file "mfw_nrf9160_1.3.2.zip" and...
Hi,
I have made my own customboard with the nrf52811. For development I have used nrf52840dk.
I´m trying to program following:
I did solder one PCB by hand. It didn...
Hi Team,
I am looking for a new readily available to test on my Nordic board 52X version.
could you please share the inputs and the source code that i can test and upload...
Hello, is there a guide on what should be done to make the sample codes for the nrf52840_dk compatible with the nrf52840_dongle? If there isnt, can I please know how one can...
Hi,
we would like to set the USBD_SERIAL according to the device serial, which will be an abbreviated version of the MAC address. I've checked the code and can only find...
Hi,
I am getting a similar error. I have nRF52832 board connected to raspberry pi for flashing and debugging using openocd. As soon as openocd command is executed I start...
Hi guys. When reading the OOB pairing example,
https://developer.nordicsemi.com/nRF_Connect_SDK/doc/latest/nrf/samples/bluetooth/peripheral_nfc_pairing/README.html
" This...
