i set up an coap/iot environment and but i was getting error while compiling code for adc i followed steps from this post devzone.nordicsemi.com/.../ here is the problem
Hi all,
I've developed a broadband vibration energy harvester that is able to pick up uW of energy from just a couple Hz all the way to 150Hz. I'm currently looking for...
We use SDK12.10 Main.c (d:\nordic\5142xx\software\org-sdk12.1\nrf5_sdk_12.1.0_0d23e2a\examples\ble_central_and_peripheral\experimental\ble_app_hrs_rscs_relay.
My question...
Solved: Well, turns out delay and SCK doesnt work well together haha. I imagined the sck signal to be a background thread of some sort. I was wrong.
Hi guys,
at the...
Hi
Im looking for a developer in Denmark to discuss ble technology with. Im trying to get better to understand the technology, because i have some ideas involving beacons...
This system does not work if I enable the third Pipe (Pipe2) .
The system is working without any problem as one RX and two TX (Pipe0 and Pipe1).
The problem on enabling...
Hello,
i have read if not all posts about writing to FLASH while using BLE. But could not find the desirable method.
What i would like to do is to write to flash from...
Hi
We have a project where 1 central shall be connected to 1-7 peripherals. The central sends a short start/stop message to the peripheral then the peripheral starts to...
I have enabled advertising fast and slow mode. But changing from fast to slow mode is almost at same time. How to configure for changing advertising mode slowly?
The following...
Hello,
I am using the 9160 to send MQTT messages which are received on AWS. I am provisioning the devices by creating a thing on AWS, getting the certificates, and loading...
I have a problem that my nRF52840 Central cannot discover one of the my nRF52840 Peripheral sensor services. With the phone I have no problem. Also other services are detected...
Hi team,
I am using NRF52833 DK with PCA10100 on it and s140 soft device version..
While I am merging the ble_app_uart example with ble_app_multiperipheral example, the...
Hi, I'm currently developing an automatic connection BLE system.
I'm using nRF52840 DK with nRF Connect SDK and S140 SoftDevice.
In fact, there exist already other...
Hi Nordic,
I would like to understand the philosophy behind the nRF9160 DK acting as a debugger. I recover my thinky:91 connecting the 10 pin flat cable from thingy:91...
I was using nrfjprog successfully about a year ago before this evaluation was suspended. When I now try it fails.
```
nrfjprog --log --program build/zephyr/merged.hex...
Hello,
I'm trying to writte a sensordriver for the nuvoton NAU7802 ADC in Zephyr using the drivers/sensor API. Here are the most important (I believe) parts of my code:...
Hello,
I've recently created a custom board based on the NRF52820 which is configured based on the datasheet.
I'm using an NRF52833 DK OB J-Link to program the device...
Hi,
I use the modified version of the USBD example(nRF5_SDK_17.1.0_ddde560\examples\peripheral\usbd) in nRF5 SDK from here . (My development kit is nRF52840DK.)
And I...
Hi, I have configured normal uart, where you send 1 tx_buf and wait for the rx_buf until you get a response. This setup was fine until the logging feature was requested. However...
Hi, I am developing a product using BLE with nrf52832. We are aiming for a BLE communication range of around 1.0m. However, if txpower is set to -20dbm, BLE communication...
