Suppose there are 10 BLE peripherals in a room and one BLE Central,then is there any way i can get the list of available peripherals[name or id.. etc]?
I am using NRF5182...
I am using SDK_11 s130 on nrf51-dk. When err_code is any value other than NRF_SUCCESS, APP_ERROR_CHECK(err_code) will cause nRF51-dk board to reset. How can one get APP_ERROR_CHECK...
Hello All,
I have problem with ble_app_uart which are not support DFU services.
When I am implement both services device will not advertise. and when ble_nus uninitialized...
[symptom]
I want to update my application/bootloader/softdevice by DFU.
Steps are shown below.
bootloder/softdevice update
if 1 step is done, application update...
Dear Developer Zone,
I am new to ANT and am looking for someone to help me to setup an example 15 channel (14 devices) ANT network using the S332 soft-device to test communication...
Hello,
i am working with the Enhanced ShockBurst proprietary protocol and i am wondering where I can find the sources of this protocol, so that I can do some changes. ...
[uart - Copy.rar](/a master _error.png ttachment/3cc01f5e2484d2b0f33e62befd3e6a62)
hello there
I am interfacing master nrf51 dk with nxp's slave lpc11u24
(1) my main...
I like to program NRF52840 Dongle without using NRF Connect Desktop (i.e, Normally we develop application program using some IDE) Can i develop application program using NRF52840...
Hello everyone
I started working on BLE devices recently and I have an Ardunio with BLE 4.2. However the maximum data rate seems to be low for my purpose ( about 60 Kbits...
Hi Guys,
I have been trying to port the older nRF51 debouncer_example (attached) into the nRF52 SDK15.2 ble_app_template example with not much luck. I realise that this...
Dear nordic,
1. Is it possible to create thread networking using dongle?
2. I want to create Thread CLI example in dongle but the problem here is UART pins and LEDS. what...
hi ,
I'm a newer , using nRF5_SDK_15.3.0_59ac345. we are using nrf52832 to get about 100 of heart rate sensors.
so first we do a scan ,and get all of there addrs. and...
Hi Dear
We plan to implement our own DFU controller on host MCU, the bootloader+softdevice+app zip file will be generated by nrftutil software.
How to exact those part...
The Capacitive Sensor low-level library documentation says:
Note:
Until Anomaly 84 (ISOURCE not functional) is fixed, the COMP solution cannot provide production-level...
Hi.
I usually used nrf52832 rather than nrf52810 since nrf52832 has an FPU, I rarely considered the computational cost for calculating floating point.
The problem is,...
Just to clarify a bit, I get that the DFU will take ages to propagate though a large network, but the first insertion of the new DFU from, lets say a cellphone, to the "proxy...
Hi, I am using nRF24L01 as a part of a larger project that involves communication between two such transceivers sending and receiving data. I am trying to get a similar but...
Could I get a code sample that shows how to drive gpio pins high on the 52840 chip on my 9160DK so I can modify it to drive analog switches to forward gpio pins to the 9160...
