Hi, I am working on a project where I want to make one nrf51288 chip as central hub and connect that to a android phone and other salve nrf51288 .
idea similar to this: ...
Hi,
I have a code programming the nRF51422 development board to write to a Sharp Memory 96x96 pixel LCD screen using SPI.
Currently the code writes two numbers and a...
I've modified the ble_app_uart example by adding GPIOTE so that the transmitter sends a character to the receiver when a GPIO pin is toggled. This part is working well.
...
Hi,
I am working on my hardware product having nRF-51422 chipset. I just came to know from forum post that
nRF-52 chips will get arduino IDE support as standalone. I want...
Hi!
I've been using PCA10028 for a long time and I had some bricking issues but I've managed to un-brick it with "nrfjprog --recover" and everything would work again. ...
I want to build nrftoolbox app in android studio. I downloaded the zip file from the github website and also the required dfu library. I unzipped both the files in a folder...
Hello,
I have a device based on nRF51822 revision 2 and SoftDevice S110 v7.1.0. Because it is revision 2 it is affected by PAN44 and PAN45, and by default the SoftDevice...
Hello everyone,
I have a few questions related to NFC in nrf52832.
1. UUID in nrf52832 NFC is Unique?
2. Can I use nrf52832 NFC for payment purposes..? if yes How I...
Hello sir,
I am using nrf52832 soc with customised board want to use as UART pins as RX pins as 23 and TX pins as 24 .Is it possible to use the RX pins as 23 and Tx pins...
Hello,
I am trying to configure a Zigbee coordinator as done in the CLI example (for example 'bdb role zc' and 'bdb start') to get data from the multi sensor example,...
Hello,
Lately we've had some problems with DFU using the NRF connect app.
The device we are using is a nrf52832 running Zephyr 2.6 with MCUBoot 1.8
When we set the following...
Hi,
Turning on A-GPS (using the SUPL library) causes our application to encounter a boot panic ("unable to find bootable image"). Similarly, running the nRF9160 GPS example...
Hi Dev team,
I have been working with the MQTT example and building up my application. I establish a successful connection with the broker and everything runs fine for 5...
I had trouble connecting the device to the computer. My computer shows that it is connected, however, in VS code, it cannot find the device. Also, when I tried to use the...
Hi,
We are using nRF9160dk in India. Currently no LTE M network in India if I am not wrong. Is it possible to use any M2M IoT sim cards like Airtel or global IoT sim cards...
We have been testing our application which is adapted from asset tracker v2 and we noticed that the LTE connection sometimes drops momentarily which causes a cloud disconnect...
Sorry, I have accidentally closed my previous question, so I repost it again.
Hello, I´m working on my audio project and I try to stream some audio data (currently a 1 kHz...
Hey,
I'm using cortex-m33 and iv'e noticed a peculiarity about one of the libraries for it that arrived with the SDK:
In the library liblwm2m_carrier.a there is a file...
Hi,
We're getting this error in the attached sample project
HAS_NORDIC_DRIVERS has direct dependencies 0 with value n, but is currently being y-selected by the following...
I am trying to build an application with Visual Studio Code using the nRF Connect SDK 1.7.1. I want to use MCUBoot and have it configured for a Serial DFU. I've modified my...
