It is good practice to prefix the includes from one's C libraries with a directory so that they are all part of the same 'include namespace'. Unfortunately the Nordic SDK...
Hi, is there an available developer in my tri-state area of Minnesota, N. Dakota, or S. Dakota? Please call me if you are available for a project for hire. The developer should...
I'm trying to design a very low power sensor that takes readings using ADC and SPI 200 times a second. I'm a bit worried by the current EasyDMA uses (1.1mA). As far as I can...
Hi, I am working on a project where I want to make one nrf51288 chip as central hub and connect that to a android phone and other salve nrf51288 .
idea similar to this: ...
Hi,
I have a code programming the nRF51422 development board to write to a Sharp Memory 96x96 pixel LCD screen using SPI.
Currently the code writes two numbers and a...
I've modified the ble_app_uart example by adding GPIOTE so that the transmitter sends a character to the receiver when a GPIO pin is toggled. This part is working well.
...
Hello,
I'm having an issue with scripting AT comands directly into the code of the nRF9160. I'm a novice at all this so I apologise if the mistake is an obvious one.
Inside...
I get "ERROR: There is no debugger connected to the PC with the given serial number." when I run e.g. nrfjprog --eraseall on command line.
Programming/debugging using VisualGDB...
Hi,
The User Guide v1.3 in Chapter 2 (minimum requirements) states "SEGGER J-Link Software" under "Software requirements". Is there J-Link software specifically for use...
I've been developing firmware for the nrf52840 for a few months using armgcc+openocd+arm-none-eabi-gcc working successfully. I recently upgraded my ubuntu version (18.04)...
Hi,
I am trying to connect to cloud MQTT (cute cat) which needs username and password for authentication. In the sample the password and username is set to NULL in client_init...
I'd like to create pc program connect to nrf51 device.
In Many document as I found, describe with dongle/DK and using a virtual com port like this.
PC -> dongle/DK include...
Hi,
I have some questions about application operation while in PSM / eDRX mode.
1. when modem is in deep sleep mode, is the application halted too ?
2. if not, what...
Hi, I am using nRF52 as a central SDK15.2 and SD132. I want to add in peripheral mac address which I want to put in the whitelist manually from the UART. But the example that...
Hi,
I read on the forum that DMA for UART block is not possible on nRF51. Is it true?
If yes, is there any way that we can enable this? Our application demands DMA for...
We developed device based on nrf52840 and android app based on nrf uart v2.0. The application runs very slow in google pixel 2xl., oneplus3 etc thich are updated to latest...
I'm working on certification for a product which uses an nRF52832 chip. I've found https://launchstudio.bluetooth.com/ListingDetails/14830 , which it seems I can use for the...
Hello,
I followed getting started guide given in the link below,
https://devzone.nordicsemi.com/tutorials/b/getting-started/posts/getting-started-with-nrf9160-dk
I started...
(there isn't an option for nRF Android or Mobile when creating a case!)
Next to each Characteristic is one or more little arrow icons:
Where is the documentation which...
Hi,My lord. I use SDK 15.3 to run the example ble_app_rscs_pca10040_s132/s112 in DK PCA10040. My cell phone Samsung S9 runs the latest version NRF connect 4.22.3. But it can...
