Hi, is there an available developer in my tri-state area of Minnesota, N. Dakota, or S. Dakota? Please call me if you are available for a project for hire. The developer should...
I'm trying to design a very low power sensor that takes readings using ADC and SPI 200 times a second. I'm a bit worried by the current EasyDMA uses (1.1mA). As far as I can...
Hi, I am working on a project where I want to make one nrf51288 chip as central hub and connect that to a android phone and other salve nrf51288 .
idea similar to this: ...
Hi,
I have a code programming the nRF51422 development board to write to a Sharp Memory 96x96 pixel LCD screen using SPI.
Currently the code writes two numbers and a...
I've modified the ble_app_uart example by adding GPIOTE so that the transmitter sends a character to the receiver when a GPIO pin is toggled. This part is working well.
...
Hi,
I am working on my hardware product having nRF-51422 chipset. I just came to know from forum post that
nRF-52 chips will get arduino IDE support as standalone. I want...
Hello there,
I've been trying to run some basic code on nRF5340 PDK. I downloaded and installed the following:
nRF Connect application v3.6.1
nRF Connect SDK v1.3...
Hi, I have developed custom board on nRF52840 based on Thread and Zigbee SDK 14.1.0.
I wants to use zb_zcl_ias_zone_set_status function to send a report of the changed zone...
I have a problem when using JLinkExe + JLinkRTTClient . My operating system is Ubuntu 18.04, and I compile the project using cmake and gcc (using great helper scripts from...
Hi all,
We have a custom board based on nRF52840, and we are using the nrf52840 DK to program our board(For programming the chip, connection from DK to our board is made...
Hi.
Device : nRF52820
SDK 17.0.2 ( Softdevice 7.2.0)
I initialized the clock as below to use USB.
And before changing to sleep mode, the clock was stopped to...
Hi，
So I was using nRF52810 with epoxy or resin coated，but actually the signal quality did not match my needs, the signal faded about 20dB compared to the device which not...
Dear Members,
I manage to display data from GSC10 sensor ? but after few minutes in idle, it can not receive a data anymore,
How can I restart again ?
Is it related...
I am using the nrf52-ble-app-uart-c-multilink-master getting data from 4 UART peripherals that are connected. Once one of the clients disconnects, I am getting an error as...
I have a custom board using nRF52840. Some boards return success from sd_ble_gap_adv_start but no advertisement is seen in nRF Connect running on a Google Pixel 4 phone. Of...
Hello,
I need help with my application.
I am developing an application running on the EV board nrf9160dk_nrf9160 .I read the following article:
http://194.19.86.155...
