Hi, is there an available developer in my tri-state area of Minnesota, N. Dakota, or S. Dakota? Please call me if you are available for a project for hire. The developer should...
I'm trying to design a very low power sensor that takes readings using ADC and SPI 200 times a second. I'm a bit worried by the current EasyDMA uses (1.1mA). As far as I can...
Hi, I am working on a project where I want to make one nrf51288 chip as central hub and connect that to a android phone and other salve nrf51288 .
idea similar to this: ...
Hi,
I have a code programming the nRF51422 development board to write to a Sharp Memory 96x96 pixel LCD screen using SPI.
Currently the code writes two numbers and a...
I've modified the ble_app_uart example by adding GPIOTE so that the transmitter sends a character to the receiver when a GPIO pin is toggled. This part is working well.
...
Hi,
I am working on my hardware product having nRF-51422 chipset. I just came to know from forum post that
nRF-52 chips will get arduino IDE support as standalone. I want...
Hi!
I've been using PCA10028 for a long time and I had some bricking issues but I've managed to un-brick it with "nrfjprog --recover" and everything would work again. ...
Hi,
I was going through the generic_ponoff_messages.h and generic_dtt_messages.h files and I observed that the message opcodes for the messages are same on both models....
As the S112 Bootloader documentation mentions, the nRF52810 does not support updating the (S112) SoftDevice.
In another question " The update-risk preventive method? " it...
Hi,
can we change duty of one channel of an instance of modules\nrfx\drivers\src\nrfx_pwm.c without affecting or introducing any glitches to other channels of that instance...
I am trying to get an SD card working with the NRF52832 chip, starting with the sd card example (SDK 14.2) using the fatfs module.
The SD card I am using is a Kingston 8GB...
Hi I'm using nrf52DK board with SDK 14.02. I wanted to use PWM Library with softdeivce but I'm getting this <error> app: ERROR 3735928559 [Unknown error code] at E:\nRF5_SDK_14...
I have a Raytac module which contains a nrf52810 AT module in it hooked up to a micro via Uart, so i can send and receive AT commands and data. I'm trying to connect to my...
Hi, I have developed one custom application and enabled DFU features in it.
With the help of nRF Toolbox mobile application, I am changing the application code.
Now I...
I just installed the nRF9160 DK but it showed yellow exclamation marks at the CDC and BULK interfaces. I'm using Windows 7. I couldn't find where these drivers are.
Anyone...
How do I use PWM on a GPIO on port 1 on SDK 15.2? The PWM library examples only sends in the pin number and seems to assume port 0. This answer seemed a bit complex and I...
Dear all,
I modified the example "ble_app_uart" based nRF5_SDK_15.2.0_9412b96 and S132 SoftDevice v6.1.0 to do some tests . But now I encounter the disconnect reason 0x22...
Hi guys, help me please.....
I want to build a device act like both keyboards and mouse. I've made some progress that the device can connect to my PC(win10) successfully...
Hi all
I developed my custom NRF52840 pcb followed by nordic design..i have done program flashing.Blinky LED also working.But Beacon advertising is not working.while flashing...
