Hello,
I have a device based on nRF51822 revision 2 and SoftDevice S110 v7.1.0. Because it is revision 2 it is affected by PAN44 and PAN45, and by default the SoftDevice...
Hi Guys,
I know this is more for software issues. But I was curious as to where I can find trusted case providers/makers for the nrf51822 Beacon. Can anyone from the community...
Hi,
Has anyone converted the Adafruit graphics library for Arduino, Adafruit_GFX.h, to be compatible with the nRF51?
Could you please advise on how to convert this Arduino...
Hi all,
I have a few questions:
How is that ADC's common mode rejection capabilities? Rejection for 60 Hz interference, etc...
The datasheet has "typical...
Hi all !
I'm trying to evaluate the throughput i can have between a Motorola 4G and the nrf51. The nRF51 is the peripheral and the phone is acting as a central.
To do...
I have a digital microphone chip, it has the CLK, DATA, LR_SEL three pins, now I will pick up the three pin nrf5283 three pin is as follows: CLK connectionI2S_CONFIG_SCK_PIN...
Windows 10 USB link. NRF connect 3.6. Followed recommended instruction on extracting firmware. Pressed switch 3 in middle of board on power up. Device showed up in window...
Hi,
I was performing a mesh DFU, using a nordic Demoboard with a serial mesh bootloader and starting DFU with nrfutil.
The DFU starts and works good (packages are sent...
I have a call to bt_scan_start after a device disconnects.
When the device connects again, I get this error:
ASSERTION FAIL [params->value] @ WEST_TOPDIR/zephyr/subsys...
I am using the nRF Connect 3.6.0 Bluetooth Low Energy app v2.4.2 on MacOS. When I pair and bond with my device it works fine. I can disconnect and connect in the same session...
Hi
I am using nrf9160 device and in my application and have to use mathematical logarithm function in my application.
Could you please help me how I can use mathematical...
Hi!
I am trying to test the CLI over BLE example. I want to use it in another application for logging data to a laptop console over BLE.
However, I am having trouble following...
Hi,
We are using NRF52832 MCU for one of our BLE based project.
We are running out of memory when specific operation performed. Buffer crashed.
What is minimum setting...
I was using log to print debugging information when the BLE_GATTS_CFG_ATTR_TAB_SIZE message popped up. It doesn't normally happen. What's the reason for that? Thank you very...
After flashing the nRF-9160-DK with the required firmware ( as instructed in this video https://www.youtube.com/watch?v=rMvW3HXLErk&feature=youtu.be ), the LED 3 is flashing...
Hello,
we need to disable UART0 to achieve low power operation of our device. This is done by running:
This works correctly on a minimal example when building using...
Hi ,
I want to know if it is possible to interface NFC text record example with ble_app_uart example. I want to run both the programs simultaneously. As the NFC text record...
