Hello,
I have a device based on nRF51822 revision 2 and SoftDevice S110 v7.1.0. Because it is revision 2 it is affected by PAN44 and PAN45, and by default the SoftDevice...
Hi Guys,
I know this is more for software issues. But I was curious as to where I can find trusted case providers/makers for the nrf51822 Beacon. Can anyone from the community...
Hi,
Has anyone converted the Adafruit graphics library for Arduino, Adafruit_GFX.h, to be compatible with the nRF51?
Could you please advise on how to convert this Arduino...
Hi all,
I have a few questions:
How is that ADC's common mode rejection capabilities? Rejection for 60 Hz interference, etc...
The datasheet has "typical...
Hi all !
I'm trying to evaluate the throughput i can have between a Motorola 4G and the nrf51. The nRF51 is the peripheral and the phone is acting as a central.
To do...
I have a digital microphone chip, it has the CLK, DATA, LR_SEL three pins, now I will pick up the three pin nrf5283 three pin is as follows: CLK connectionI2S_CONFIG_SCK_PIN...
Hi there~
I want to install and run my own nrfutil on my pc run with windows 10, but I cannot get throw it.
After generate the exe file, nrfutil outputs some error.
...
Hi,
I am trying to build an "asset tracking" application in Windows 10 using power shell, but it failed.
Please find the logs below and direct me to the correct path....
HI,
I am trying to load the Asset tracking project in segger embedded studio, but it is giving the following error:
Segger Embedded Studio Version: " SEGGER Embedded...
I'm looking at reference schematic/layouts for the NRF52840 and fail to see how the PCB antennas are 50 ohms. (I understand that it's frequency dependent, and that resonant...
Hi,
I'm doing power measurements for nRF52-DK (SOC nRf52832) and for nRF52840-DK. I'm able to measure reasonable figures from the external supply connector (P21) of nRF52840...
Hello,
I was trying to open assert tracker application on MAC os, in segger studio v4.18.
However, after I open the "Open nrf connect SDK project.." and filled out the...
Hi,
We're seeing DFU issues on iOS that we're not seeing on Android. To make things simpler I've reproduced the problem with pca10040 and nrfconnect for iOS.
I'm using...
Dear support,
I am experiencing an issue while using the SPIS peripheral. The issue seems to be the same one as https://devzone.nordicsemi.com/f/nordic-q-a/33727/new-in...
Hi,
We use the ECB peripheral to encrypt and decrypt data with a proprietary driver implementation (which is not that different from the one in the SDK). It is working fine...
Hi,
We are looking for information about the possibility to integrate the NRF9160 in our new product which is integrated in a sealed metal enclosure.
I have not made any...
Hi,
currently i'm dealing with problems with this https://github.com/NordicPlayground/fw-nrfconnect-nrf/pull/1300 pull request which have wrong title and wrong changes ...
Hi everyone!
I'm wondering, is FSK compatible with the nRF52832. I want to emit 2 differents frequencies that the receiver will be able to recognize. If yes, How to create...
Location: Utah.
Well, I was testing a Thingy:91 board here with the very first boot and test with the iBasis SIM card which comes with the product.
Everything goes...
Hi,
I have qestion about crystal 32.768 kHz follow schematic as attached file.
Is it nessary to use ?
Is it possible, Can I remove this crystal ?
Thank you
Best...
