Hi Guys,
I know this is more for software issues. But I was curious as to where I can find trusted case providers/makers for the nrf51822 Beacon. Can anyone from the community...
Hi,
Has anyone converted the Adafruit graphics library for Arduino, Adafruit_GFX.h, to be compatible with the nRF51?
Could you please advise on how to convert this Arduino...
Hi all,
I have a few questions:
How is that ADC's common mode rejection capabilities? Rejection for 60 Hz interference, etc...
The datasheet has "typical...
Hi all !
I'm trying to evaluate the throughput i can have between a Motorola 4G and the nrf51. The nRF51 is the peripheral and the phone is acting as a central.
To do...
I have a digital microphone chip, it has the CLK, DATA, LR_SEL three pins, now I will pick up the three pin nrf5283 three pin is as follows: CLK connectionI2S_CONFIG_SCK_PIN...
Hello, Nordic Team, I'm embedded designer from Russia, discovered your amazing wireless MCU NRF52832. I looked through your SDK and peripheral drivers, and unfortunately found...
Hi,
I am working on a project of throughput data from sensors to my central via nrf52832 through a notifying service (SDK14.0.0, S132).
As explained in several questions...
In the Infocenter, there is a section about adding support for custom boards. It advises the creation of custom_board.h modeled after pca10040.h. However, the configuration...
I am starting a nRF52832 project that is based on the GCC + Makefile build system that is provided with the example projects. In my particular case, I need to execute a python...
Hello, everyone~
I'm trying to use mac to develop nRF52832 DK. I have installed the lastest J-Link driver and SES. I downloaded nRF5 SDK 14.2.0 and just open ble_hrs project...
I get nrf mesh SDK form: http://www.nordicsemi.com/eng/Products/Bluetooth-low-energy/nRF5-SDK-for-Mesh/(language)/eng-GB
I want to use the serial example to control a mesh...
I use the advertisement timeout to shut down the MCU. Is is possible to reset the advertisement timeout on the fly, e.g. if there is any activity I would like to extend the...
Hi,
I'm interfacing acceleration via BLE using NRF52.
I'm using timer to get the sensor value and update the characteristic value related to this sensor using sd_ble_gatts_hvx...
Hi,
I tried to make a software update (I tried application, bootloader, SoftDevice and any combinations) over BLE using the secure_dfu_ble_s132_pca10040 example but after...
Hello. I have a problem. After using nfc, current consumtion still high. I found that I need use HAL_NFC_ENGINEERING_A_FTPAN_WORKAROUND macros. But when I specify this macros...
Hi All,
I am going to get EMI/EMC testing for my custom board made on nRF52832 WLCSP package. Can you please share/suggest the firmware used in EMI/EMC testing.
hi everyone
i want use s130 with my ble nrf1822 i'm wondering about the modifiaction that i have to do under keil 5 in option for target for example the configuration that...
Hi,
I try to use the dfu update OTA with ble secure bootloader.
If the Flash is erased and only the SD v5.0.0 and the own Bootloader are programmed a update OTA is working...
When making a bluetooth mesh network, what is a good rule of thump for the ratio between servers and clients?
I am thinking of implementing the server-client-model scheme...
Hi Engineers!
We used SDK13 for our Project (multilink BLE with 1xServer & 4x PeerS) and now move to SDK14.2, almost done except only USBD.
if we use SDK13 driver...
