Hi,
Has anyone converted the Adafruit graphics library for Arduino, Adafruit_GFX.h, to be compatible with the nRF51?
Could you please advise on how to convert this Arduino...
Hi all,
I have a few questions:
How is that ADC's common mode rejection capabilities? Rejection for 60 Hz interference, etc...
The datasheet has "typical...
Hi all !
I'm trying to evaluate the throughput i can have between a Motorola 4G and the nrf51. The nRF51 is the peripheral and the phone is acting as a central.
To do...
I have a digital microphone chip, it has the CLK, DATA, LR_SEL three pins, now I will pick up the three pin nrf5283 three pin is as follows: CLK connectionI2S_CONFIG_SCK_PIN...
Hello, Nordic Team, I'm embedded designer from Russia, discovered your amazing wireless MCU NRF52832. I looked through your SDK and peripheral drivers, and unfortunately found...
Thanks Stefan. The zip file making and updating steps work perfectly for me, if I follow your steps and make it from your stock pre-built "dfu_test_app_hrm_s132.hex". My question...
Hi,
I've noticed that when using SPI without a Soft Device or BLE function calls, the SPI peripheral is easy to control and operates correctly.
This nice operation stops...
hi,everyone.
I try to use ble urat sample for bonding by passkey entry.
and connection established and to bond. i try to entry passkey by uart.
but when i key the passkey...
Hi!
Can you please recommend a LDO IC for a USB/Li-polymer Battery power for the nRf51822 please? The LDO needs to drive the nRf51822 and a couple of sensors such as Gyro...
I'm trying to get the ble_app_hrs example working in Eclipse, but the stack pointer is not setup correctly. It's at the start of the RAM (0x20000000), and therefore it already...
I'm implementing an Android 4.3 app which uses an nRF51822 and the BLE proximity profile. I have the following as starting points for the app code:
The BLE sample...
I can't seem to find the required current of NVMC doing erase and write. The product spec has only timings but not more. Could someone from Nordic provide some figures? Experimental...
Hi,
I have a C# app connecting to 51822 devices, doing data/firmware download. When I try to send erase page command (before write), erase works, but there is a disconnect;...
Should we keep track of this by monitoring the write events or poll the gatts value via the softdevice?
It looks like it's faster (+shorter = less consumption) to monitor...
Over the past few months I have worked extensively on a few different projects that all utilize the nRF51422. In some recent debugging of GPIO issues (both relating to SENSE...
As the title says, I am wondering when the new SDK will be released to support the nRF51822 hardware revision. It looks like the latest (v4.4.1) doesn't have anything new...
the very similar issue
Friday, October 04 2013, 02:23
I have staerter kit + development kit. I have installed all required software and can't loat example code because...
I Every one !!! Thank for the possibility to participate in this forum.
I am trying to initialization configuration of my nRF24L01+ .
I am using CY8C3866AXI-040 from Cypress...
Hi, i'm experimenting RTC1 using the app_timer module (not using S110 soft device), and i find some problems onRTC prescaler. If i set values as stated in the datasheet, for...