Hi, is there an available developer in my tri-state area of Minnesota, N. Dakota, or S. Dakota? Please call me if you are available for a project for hire. The developer should...
I'm trying to design a very low power sensor that takes readings using ADC and SPI 200 times a second. I'm a bit worried by the current EasyDMA uses (1.1mA). As far as I can...
Hi, I am working on a project where I want to make one nrf51288 chip as central hub and connect that to a android phone and other salve nrf51288 .
idea similar to this: ...
Hi,
I have a code programming the nRF51422 development board to write to a Sharp Memory 96x96 pixel LCD screen using SPI.
Currently the code writes two numbers and a...
I've modified the ble_app_uart example by adding GPIOTE so that the transmitter sends a character to the receiver when a GPIO pin is toggled. This part is working well.
...
Hi,
I am working on my hardware product having nRF-51422 chipset. I just came to know from forum post that
nRF-52 chips will get arduino IDE support as standalone. I want...
Hi!
I've been using PCA10028 for a long time and I had some bricking issues but I've managed to un-brick it with "nrfjprog --recover" and everything would work again. ...
Hi,
I'm testing a BLED112 USB Dongle from Bluegiga ( www.bluegiga.com/.../).
I have not been able to use see the Nordic Board advertising. Currently testing ble_app_proximity...
I was wondering would it be possible to use a 50 ohm IC Antenna ( like this one ) for the nRF51822 with the matching circuit given for the nRF24 ( link here )?
It seems...
Hi,
Is there any difference(data rate) between sending large data packets through single characteristics and multiple characteristics?
I have created one characteristic...
Hi everone!
I need to get a timer setup which repeatly fires 2 IRQs. The first i.e. after a timer count cc0=500 and the 2nd count cc0=700. After 700 ticks the timer value...
Hi,
I've noticed that when using SPI without a Soft Device or BLE function calls, the SPI peripheral is easy to control and operates correctly.
This nice operation stops...
hi,everyone.
I try to use ble urat sample for bonding by passkey entry.
and connection established and to bond. i try to entry passkey by uart.
but when i key the passkey...
Hi!
Can you please recommend a LDO IC for a USB/Li-polymer Battery power for the nRf51822 please? The LDO needs to drive the nRf51822 and a couple of sensors such as Gyro...
I'm trying to get the ble_app_hrs example working in Eclipse, but the stack pointer is not setup correctly. It's at the start of the RAM (0x20000000), and therefore it already...
I'm implementing an Android 4.3 app which uses an nRF51822 and the BLE proximity profile. I have the following as starting points for the app code:
The BLE sample...
I can't seem to find the required current of NVMC doing erase and write. The product spec has only timings but not more. Could someone from Nordic provide some figures? Experimental...
Hi,
I have a C# app connecting to 51822 devices, doing data/firmware download. When I try to send erase page command (before write), erase works, but there is a disconnect;...
Should we keep track of this by monitoring the write events or poll the gatts value via the softdevice?
It looks like it's faster (+shorter = less consumption) to monitor...
