Hi all,
I have a few questions:
How is that ADC's common mode rejection capabilities? Rejection for 60 Hz interference, etc...
The datasheet has "typical...
Hi all !
I'm trying to evaluate the throughput i can have between a Motorola 4G and the nrf51. The nRF51 is the peripheral and the phone is acting as a central.
To do...
I have a digital microphone chip, it has the CLK, DATA, LR_SEL three pins, now I will pick up the three pin nrf5283 three pin is as follows: CLK connectionI2S_CONFIG_SCK_PIN...
Hello, Nordic Team, I'm embedded designer from Russia, discovered your amazing wireless MCU NRF52832. I looked through your SDK and peripheral drivers, and unfortunately found...
Thanks Stefan. The zip file making and updating steps work perfectly for me, if I follow your steps and make it from your stock pre-built "dfu_test_app_hrm_s132.hex". My question...
Hi!
I'm trying to configure my NRF8001 module with the help of nRFgo studio. I'm using Nordic UART over BTLE service template. The module can be discovered via nRF Master...
Hello Recently, after a long time not using my Thingy52, I encountered a problem with it. I cannot connect to the device. Earlier it worked fine (can't remember if it was...
Hi,
I've just bought nRF Dongle and wanted to start using it with nRF Connect app for desktop, however nothing happens when I plug it in: no sound of connecting a USB device...
Hardware:
1. STM32L476, nrf52832
Software:
1. SES(Segger Embedded Studio)
We had finished our production development on Keil, and right now we want to transplant platform...
HI team,
I like to interface methane, hydrogen and moisture sensor in my custom board which is going to use nrf52840 soc. i am in development stage. for outdoor application...
I would like to know if there is any documentation that speaks of security for push notifications. For example, that talk about security when using a nRF52 device as a beacon...
Hi,
Is it possible to make infinite GATT connection ? I set auto connect in android central app and my program in nrf51DK works. But only 4 hours.
Hardfault is almost...
When I try to build example in SDK 12.3.0, I always get the hex file for nRF51422 target, how should I change the target to build the example for nRF51822?
I set the variables...
I would like to get the timesync example running on the Sparkfun nRF52832 Breakout board .
I can currently download it to the nRF52832 DK using Segger Studio (after making...
Hi all,
I am beginner in Java, I have experince just with assembler and C. I did only one app before in java, with Laird libraries, because we have Laird boards using Nordic...
Hi. I've seen many questions here regarding BLE throughput, I've been trying to get something better than the 200 B/s I'm getting.
I am using a nrf52832 as a GATT server...
I tried to sniff Mesh Packets send with the Light Switch Example but I didn't get any.
For sniffing I use the nrfsniffer v2 with the nrf dongle and for the Light Switch...
I'm trying to get nRF UART logging to work and have included all the nRF_Log libraries as per the blinky example (which works).
However, upon building, I'm getting
"nrf_fprintf...
I am currently using the NRF24l01+ but i want to know if I should be using a different product for my application. I am sending very small amount of information (such as hex...
