I'm still on stack 8.0.0 so it might have been fixed since. I have noticed that if the other side de-asserts CTS the Nordic code will leave the TX asserted in a Break condition...
Hello,
I'd like to ask what is the data rate when using BLE OpenMesh network and how much it depends on network architecture.
I'm considering using it in a network consisting...
Hello Nordic Community,
I need to know how to import my PCB design from Eagle to CST Studio to simulate it and I need to know if the simulation step will be useful to enhance...
Hi.
I'm trying to get Apple notifications to nrf52. And specifically to listen both regular ANS (for android) and ANCS (for iOS) events depending what sort of phone is...
I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
I am trying to implement mesh with NRF SDK V17.
But nrf5_SDK_for_Mesh_v5.0.0.
When I build the light_switch application, I get the error "boards.h No such file or directory...
Product info:
NRF52840
nRF5_SDK_17.1.0_ddde560
s140_nrf52_7.3.0_softdevice
I am working on a product with a NRF52840 and SDK 17.1.0 and a cell modem. This product...
I'm having no luck in getting JLinkExe or nrfjprog to see my BMD-350 device on my custom PCB.
I have read though all the threads here that reference similar issues and...
Hi
Because the nRF52 SDK doesn't support scheduler server modeI and scheduler setup server model, but I need this model, and I don't know how to implement by myself, could...
As referenced in a previous ticket: devzone.nordicsemi.com/.../nrf9160-mqtt-simple-example-configured-to-talk-to-test-mosquitto-org-using-mutual-tls-on-port-8884 We are seeing...
Using nRF Connect SDK v2.0.0 on Windows in VS Code. Hardware is a U-Blox BMD340 demo kit with nRF52840.
We've built and run the following OpenThread sample applications...
Hello,
I am trying to use http requests on Thingy91 and therefore I tried with the sample from zephyr/samples/net/sockets/http_client.
I can build the project without...
I have a conexio stratus board that I would like to debug the modem with the LTE Link monitor. I am not using the Zephyr frame work, but I can flash pre-compiled hex files...
There's a few threads out there with similar questions, but I haven't seen a direct answer to this.
If I build with nrf5340dk_nrf5340_cpuapp, can I use the entire application...
Hi,all~
The program runs on nRF52833. At the beginning, MCU sends data to nRF52833 through serial port, and the data can be received correctly(pic one）. When I use THE...
I currently have an issue where by the Chip-Select is not toggled at all when configuring the csn pin to pin <18> on the Nrf52840 using Zephyr (version 2.7.1).
See dts configuration...
Hi All!
I am using NCS v2.0.0 and nrf52820 custom board and an example to test is radio test . I tested that example with nrf52833DK , code is executing/ printing messages...
