I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
1. I've noticed while using tools like NRFConnect that most BLE devices in my proximity do not include the device name in the advertising packet. My assumption is the developers...
Hello, I am unable to connect thingy 52 with my laptop, I have NRF connect v2.6.1 installed but it is unable to find thingy.
Thingy is not connected with any other device...
hello,
I am using the SDK15.2 for development.
I want to set a central address in peripheral like the whitelist function via uart without bonding.
This code is about...
Hello,
We are working with nrf52832 which have a custom application with SDK 13.1 and softdevice s132_nrf52_4.0.5_softdevice, we have migrated to sdk 15.2 s132_nrf52_6.1...
Hello,
I am trying to program my nrf52840 dongle to act as a BLE central device and I am using the USB CDC ACM Module. I am facing the following issues:
1- I was able...
Hi.
Softdevice 6.0.0
SDK 15.0.0
IDE IAR 7.80.4
Chip NRF52832
I buid progect buttonless DFU in IAR.
I added peer_id.c, peer_data_storage.c, peer_database.c, peer_manager...
I have successfully written the public certificate (type 1) using nrf_inbuilt_key_write().
When I then try to delete it with nrf_inbuilt_key_delete(), however, it returns...
Hello All,
Does the module have internal regulators that can be used to power connected peripherals? There is the 1.8V output for Sim_1V8. Is this strictly dedicated to...
Hi Everyone,
I am using the following peripherals in my project
2 UARTE.
2 ADC
1 TWI
BLE
GPIOTE interrupt for 2 buttons
TWI and ADC and BLE and GPIOTE are not...
Hi there,
I cannot find a good example of one central and one peripheral, where they use a passkey between them, with one of them, the peripheral, is where the user type...
i am using ble central example from sdk15.the peripheral i want to connect with Nrf52832 is not a Nordic device.Peripheral have 5 different services.now till i successfully...
