Hello Nordic Community,
I need to know how to import my PCB design from Eagle to CST Studio to simulate it and I need to know if the simulation step will be useful to enhance...
Hi.
I'm trying to get Apple notifications to nrf52. And specifically to listen both regular ANS (for android) and ANCS (for iOS) events depending what sort of phone is...
I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hello Nordic Team, We haven chosen a nRF52805 SoC and MDBT42T Module and would like to operate with 2 i2C sensors on two different Pin-pairs. Since the nRF52805 only has one...
Here's what i am struggling with: my code generates a error while building for every line where i use a function starting with "nrf_drv_gpio_..." saying there is an undefined...
Hi all,
I am about to purchase NRF51-DK Nordic Semiconductor ASA | Development Boards, Kits, Programmers | DigiKey but this says for nRF51422, nRF51822 series Transceiver;...
Hello,
I am using the peripheral uart sample and it works fine. My issue is that whenever the buffer is full it automatically sends the data from the com. How do I stop...
I'm working on the nRF5340 using the newest release of the nRF SDK, SoftDevice and zephyr project. I get the connection index from our application but need to retrieve the...
I change nRF52832 firmware to support DFU OTA. But ble_dfu_buttonless_async_svci_init() failed with errCode=0x4.
0> <info> app: Version 1.2.1 0> 0> <info> app: ========...
When I use Keil to build project for supporting DFU OTA. Keil shows changing *.o to *1.o. Is it normal?
Build started: Project: ble_app_band_v4 *** Using Compiler 'V5.06...
We are using the Softdevice controller from the nRF Connect SDK on the nrf5340 processor and have implemented the commands to read and set the tx power level in the controller...
I want to take readings from SHTC3 temperature and humidity sensor from a custom board. Using I2C master as nrf5340 how can I take readings from slave custom board. Please...
Hi guys.
With the nRF52840 DK(PCA10056) running the Running Speed and Cadence Service (RSCS) example, the nRF Connect app on my Galaxy S10/Android 12 was able to scan the...
For emission testing, we need to be able to use some DTM commands (such as: transmitter test) inside our normal firmware.
The normal firmware uses the softdevice for BLE...
