Hi.
I'm trying to get Apple notifications to nrf52. And specifically to listen both regular ANS (for android) and ANCS (for iOS) events depending what sort of phone is...
I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hello,
I am using nrf52 DK to program an nrf52805 with the ESB protocol. My nrf52805 is in slave mode compared to a micro Stm8l serial connected.
I'm having trouble configuring...
Hi everybody,
I am working in a project where there are one central_UART with multilink and diverse peripheral.
The devices are a custom board Fanstel BC840, nRF Connect...
Hello ;
We used NRF9160-SICA-B1A-R in our project. We have to choose the old version (NRF9160-SICA-R7) as NRF9160-SICA-B1A-R is out of stock. the only difference, Some of...
Hello,
I am attempting to implement cell tower triangulation using unwiredlabs.com's api.
I have single-cell geolocation working. I am having trouble getting multi...
To measure the antenna in band 20, you can send a carrier in the frequency range from 832-862 with the command "AT% XRFTEST = 1,1,20,8320,0,1,4".
To measure the antenna...
Hi,
I am using nRF Mesh SDK 4.1 and nrf SDK 16. I started with the light switch client example on a DevKit.
I am trying to change the publication address of the client...
Hello, DevZoners!
Hope you all doing great!
I have 2 9160DK's and for a few weeks now I've been trying to connect to the LTE network and then connect to the nRF Cloud...
I have changed the ram start and ram size, but as soon as i am adding the 10th characteristic to my second custom service, the program is crashing? i've also changed BLE_GATT_DB_MAX_CHARS...
What is the maximum file size of the LTE Modem firmware update we can expect on the 9160 platform? I am trying to plan out our external flash size and partitions.
The...
I recently switched from 1.5.1 to 1.6.1 and I'm now finding the SLM is misbehaving.
When I try to send a large payload such as 933 bytes of data, I find the CTS signal goes...
I successfully built, run and tested the sample: gps on my nRF9160 DK , without using the SUPL client library.
I then tried to build and run this sample: gps with the SUPL...
Hello,
I have been asked to research a possible solution to add support for executing REST calls to the AWS cloud. I see a library and API for making REST calls to nRF Cloud...
Hi,
I am looking at ways to offer the GPS assistance data from NRF Cloud (or similar) through our own server. The NRF Cloud is unavailable from within our network and we...
