Hi.
I'm trying to get Apple notifications to nrf52. And specifically to listen both regular ANS (for android) and ANCS (for iOS) events depending what sort of phone is...
I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
In standard sdk 17.0.2 is it possible to know which devices did i accidently disconnect?(Interactive command s140)
for example
my central is the interactive command...
Hi, I used NRF52 DK and NRF Connect SDK 1.6. I used the st_ble_sensor sample with no changes. When I press Button 1, I expect to get a notification on the central device....
Is there a straight forward guide that demonstrates how to changes the Asset Tracker V2 application from "Active Mode" to "Passive Mode"?
Referencing the notes on the application...
Hello,
I have been working with nRF52832 microcontroller on a custom PCB. Currently, we are implementing OTA updates through BLE, and developing using the nRF toolbox app...
Hi,
I am trying to program the nRF52 DK with external j-link Base. I am using Debug IN P18 connector and connected the following pins
j-Link base nRF52 DK Debug IN P18...
I'm a little confused about how to determine the value to set in the registers for the internal capacitors. If I select 10pF, that means that there is an internal C1 and C2...
Hey everyone,
I basically have the same question as it was discussed in this ticket: How to get unicast address on mesh server. - Nordic Q&A - Nordic DevZone - Nordic DevZone...
Hello, I'm currently planning a product that involves Bluetooth technology and came across the NRF5340 chip. I see that I can get the development kit which is a board with...
Hi,
On nRF5340 development board I followed the instructions in this link and ran the blinky example successfully: Getting Started Guide — Zephyr Project Documentation...
I got an error here err_code = pm_init(); APP_ERROR_CHECK(err_code);
<error> nrf_ble_lesc: nrf_crypto_ecc_key_pair_generate() returned error 0x8502.
<error> peer_manager...
I am using the BLE sniffer in Wireshark (nrf 52840 dev kit board) to attempt to capture packets between a BLE device and android phone. I am able to sniff advertising packets...
