Hello Nordic Community,
I need to know how to import my PCB design from Eagle to CST Studio to simulate it and I need to know if the simulation step will be useful to enhance...
Hi.
I'm trying to get Apple notifications to nrf52. And specifically to listen both regular ANS (for android) and ANCS (for iOS) events depending what sort of phone is...
I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
We plan to design a module that wirelessly connects via the nRF52833 chip with RF amplification, 2 PWM outputs and multiple
Digital I/O interfaces，One ADC interface and...
I have developed the application code for light node in ble mesh network.
I was able to see this error quite often:
app_error_weak.c, 115, Mesh error 4 at 0x00000000 ...
Does the 9160 GPS module have a built-in LNA? Is it possible to adjust the GPS receiving sensitivity?
We hope that the wireless index of wearable products when worn on the...
The set up which are used are a nRF52840 dongle programmed through nRF52832DK's debugger. After executing "erase all" in Programmer app, which erased the bootloader, it's...
We are using NRF52832 based Module in our design. Currently BLE Services & characteristics used in our firmware: 1. Custom Service characteristic 1: 37 Bytes characteristic...
Hi,
I understand that BLE Logical Link Control and Adaptation Layer Protocol is responsible for protocol multiplexing capability.
Can you please explain what kind of protocol...
Hey,
when i call:
otLinkSetChannel(OTInstance, ThreadChannelToUse);
from the very beginning of the programm:
void main(void) { int ret; ret = InitLEDs(); InitTemperatureMeasurement...
We are using nrf5340-dk to communicate with nrf5340 custom board and trying to search for the other sensors' addresses. There is secure mode and unsecure mode CPU. Which mode...
Hi.
My first attempt to get SAADC to work was:
NRF_SAADC->INTENSET = (SAADC_INTEN_RESULTDONE_Enabled << SAADC_INTEN_RESULTDONE_Pos) | //A result is ready to get transferred...
Hi,
Can I connect a 3.7V Li ion battery to the dongle VBUS keeping the SB1 and SB2 configurations as default?
Would this 3.7V applied to IC's VBUS pin cause any issue...
I want to view extended advertising, auxiliary advertising , LE coded data.
i had installed nrf sniffer app wireshark but it doesnt display this.
Ellysis bluetooth tracker...
